Your cart is empty.
Your cart is empty.Carburetor main jet tool for S&S Super "B", "G" and "E" carburetors to install and remove main jets. An essential tool when changing the main jets on S&S carburetors with 72 series jets. The sliding handle allows this tool to be used in spaces with little clearance. No need to worry about stripping the heads of your jets with a flat head screw driver. This tool will also allow you to change the jets without taking the carb off the bike.
Derek weaver
Reviewed in the United States on April 22, 2025
Good little tool
Big Frank
Reviewed in the United States on May 14, 2024
Extremely well made!!! Great craftsmanship!!!
Greg M
Reviewed in the United States on December 23, 2024
Removes and replaces the main jet without removing the float bowl.
Yvonne
Reviewed in the United States on November 2, 2024
Makes jet changes easier on s&s super e carburetors
Jamie
Reviewed in the United States on August 19, 2023
I was looking for a tool like this for Model A Ford jet removal but this is the only one I found. The diameter is too big but I turned it down on my lathe for a perfect fit. A Very handy tool. Actual Diameter of tool shaft is 51/128" (10.14mm) Alignment Pin diameter 9/64" (3.62mm) I turned mine down to fit specific Model A Carbs. Well made item.
Recommended Products
$126.44
$ 58 .99 $58.99
$6.99
$ 2 .99 $2.99