Your cart is empty.
Your cart is empty.This suspension strut mount is precision-engineered and rigorously tested to provide reliable replacement for the original equipment on specific vehicles. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Chrysler Sebring: 2001, 2002, 2003, 2004, 2005, 2006] - [Dodge Stratus: 2001, 2002, 2003, 2004, 2005, 2006]
KyKyNo
Reviewed in Mexico on June 23, 2024
Lo compré pero la base es más grande de los normal lo quería para un stratus 2005 versión se el resto del contenido es compatible
Phala Sok
Reviewed in Canada on June 30, 2022
It work perfectly with my 2003 chrysler sebring.
Xmonders
Reviewed in the United States on April 16, 2022
Just like the OEM, perfect fit. Except the mount is also made out of aluminum just like the OEM. Mine was torn apart because the corrosion. I’m living in the State of Michigan where we salted the roads and Freeways. The only way to last a little longer is to spray paint all over this mount with multiple layers. Hopefully my advise will help you folks.
Victoria R.
Reviewed in the United States on June 27, 2018
This is a simple solution to replace the poor quality aluminum parts that Chrysler installed at the factory with steel This will solve the loud bump and rattle that occurs in the rear of all the Sebring models. This arrived in 2 days, came with simple instructions. Fair price and it is a smooth quiet ride again.
2oldmechanic
Reviewed in the United States on March 3, 2016
Great product at a great price. Contains everything needed to replace OEM upper strut mount that fails do to corrosion.
pawel gryglik
Reviewed in Canada on April 13, 2015
good price
Miroslaw Brodzik
Reviewed in the United States on September 25, 2014
good and cheap part
Mike I
Reviewed in the United States on August 16, 2013
Watched a youtube video to install. Everything was there but had to re-use the nuts. So glad I bought this kit, the old rubber parts were useless.
JosephV
Reviewed in the United States on July 18, 2013
This shock mount fit perfectly for replacing the stock shock mount in the car. The original disintegrated in dust, literally. Almost appeared as if it was not painted to protect it against corrosion. This replacement is painted. The studs are much longer than the original mount, but posed no issues.
Shawn
Reviewed in the United States on August 7, 2012
I'm not happy with the aluminum material, but after the research, I'm sure that's the only type you can get. There is no steel-made strut mount. Since that's the only choice, I would say not bad. Although I'll be pissed off if that parts need to be replaced again only a few years later.
ReevesRacing
Reviewed in the United States on March 14, 2012
I used these to replace the broke/corroded stock aluminum mounts on the back of our 2004 Chrysler Sebring sedan. The factory mounts are bare aluminum and one of them had corroded into two pieces and the other one was getting ready to do the same. I used these to fix the problem and also added KYB 344610 GR-2 Shocks at the same time. I cut one coil spring off to give the car just a tad bit lower stance in the back. Worked great.
Recommended Products
