Your cart is empty.
Your cart is empty. Pack of 12 lattice support clamps that fit rods up to 12.5mm in diameter. Clamps are made of high quality metal with a silver finish. Tighten clamps using an Allen wrench. Avoid overtightening.
Twelve clamps only. Rods pictured are not included.
Clamps measure 29mm x 28mm with an inner diameter of 13mm.
Eisco Labs proudly manufactures its own products using state-of-the-art equipment, and following the highest standards of quality control.
Each product is carefully designed by a team of laboratory professionals and experienced engineers with quality and durability in mind. They are manufactured with only the highest grade, raw materials and according to international quality standards to ensure that they can withstand use in even the toughest laboratory environments.
Stewarts
Reviewed in the United States on July 5, 2022
Does not secure properly. The set screw isn’t set right and too short. It isn’t curved enough to secure the rod. This causes the set screw to just push the rod out. Very dangerous if used.
MS24
Reviewed in the United States on July 1, 2021
ONLY fits half inch lattice
Larry V.
Reviewed in the United States on May 11, 2018
as advertised
Kelly Irwin
Reviewed in the United States on December 20, 2014
Clamp set-screw is flared incorrectly. These clamps do not work as the set-screw passes the rod to the outside. Total fail.
Recommended Products
$77.50
$ 35 .99 $35.99