Your cart is empty.
Your cart is empty.Converts pedestal fans into mobile floor fans for easy portabilityFits 1-1/2" to 2-1/4" dia. colums and 28" and smaller basesDolly is made of 1" x 2" x 18 gauge tubular steel legs on 16" centersTwo 6" x 1-1/2" non-marring rubber wheelsIncludes post collar and bracket, Lot of 1
sllimb
Reviewed in the United States on March 11, 2021
Very well made pedestal fan wheel set. Only issue was the bolts to attach it to the fan were too short. I had to replace bolts with longer ones. Otherwise, very nice.
murf
Reviewed in the United States on November 6, 2021
Put this on my harbor fright fan perfect fit. Makes it very easy to tip over and move around the shop. I put one on all my fans.
Deseree Aragon
Reviewed in the United States on August 3, 2020
Hard to put together
Cpug5150
Reviewed in the United States on July 15, 2020
Cumbersome. Hard to move fan even with it installed because the fan blade's housing gets in the way. Then if the fan has oscillation and the housing shifts on you when tipping it back to roll, it gets even harder to move.Product only fits certain diameter fan pedestals also. Something I didn't see noted in description. Would not fit my Lasko pedestal but fit my Garrison which are both same size fan (I think 30"). However, the two pieces that cup the pedestal's shaft still didn't fit flush together. Because of that, the bolts that attach the dolly are way too short, again, partly because of the two housing pieces that cup the shaft not being completely flush with each other. Took like an hour just to get all four bolts together cause every time I got one nut & bolt to catch, it made the other side spread too far apart for the bolt to make it through both sides. I had to eliminate the split washers.It comes with an adapter for different a size pedestal, but it's for pedestal that have even smaller shafts. Maybe this dolly designed for smaller fans than mine, but my fans are pretty average in size and look just like the fan used to illustrate the dolly in the listings picture. Very disappointed. Better off just picking the fan up to move it like I was doing.
KnowYourLimits
Reviewed in the United States on October 15, 2020
Well designed and sturdy. I use this on my iLiving 30” fan. Only giving 4 stars on install because the bolts are short and difficult to thread the nuts plus washers. Another 1/4” longer would make it far easier. I had to use visegrips to pinch the collars.
Emmett Woodruff
Reviewed in the United States on September 9, 2019
Perfect fit. It makes moving my heavy fan easy!
Rob Pont
Reviewed in the United States on July 8, 2019
Easy to install, feels very sturdy and well built. The wheels don't spin very freely, even at only "snug" or less tightness.
J A
Reviewed in the United States on November 7, 2019
These are the best for industrial fans. Make it easy to move those huge fans
Recommended Products
