Shopping Cart

Your cart is empty.

Your cart is empty.

LIGHTENED FLYWHEEL fits Yamaha Banshee shaved rotor 1987-2006 + OEM nut

5.0 Write Review
Free shipping on orders over $29.99

$74.99

$ 33 .99 $33.99

In Stock
  • Flywheels are typically made of steel and rotate on conventional bearings; these are generally limited to a maximum revolution rate of a few thousand Compatible with RPM. High energy density flywheels can be made of carbon fiber composites and employ magnetic bearings, enabling them to revolve at speeds up to 60,000 Compatible with RPM (1 kHz).
  • Flywheels are often used to provide continuous power output in systems where the energy source is not continuous. For example, a flywheel is used to smooth fast angular Compatible with Velocity fluctuations of the crankshaft in a reciprocating engine. In this case, a crankshaft flywheel stores energy when torque is exerted on it by a firing piston, and returns it to the piston to compress a Compatible with Fresh charge of air and fuel.
  • Smoothing the power output of an energy source. For example, flywheels are used in reciprocating engines because the active torque from the individual pistons is intermittent.
  • Delivering energy at rates Compatible with Beyond the Compatible with Ability of an energy source. This is achieved by collecting energy in a flywheel over time and then releasing it quickly, at rates that exceed the abilities of the energy source.


An ATV’s flywheel is the most important part of its electrical system along with the ATV’s stator. While the stator is stationary, the ATV’s flywheel is attached to the crankshaft and spins around the stator in unison with the engine’s RPM speed. Permanent magnets are attached to the inside rim of every flywheel. These magnets generate electricity when they pass over the stator’s wire coils. The ATV’s flywheel also communicates with the pick-up coil. A flywheel usually has one or more bumps on its outer rim to tell the pick-up coil where the engine’s rotation is at, so it can give that information to the CDI box.

* RAPTOR 660
* RAPTOR 700
* BANSHEE
* BLASTER 200
* YFZ450
Product Photos
Product description

This is a complete LIGHTENED + Banshee flywheel + new fits Yamaha OEM factory crank nut

Works perfectly, and is perfectly round.

Looks and works great, ready to install.

Will fit any year fits Yamaha Banshee 1987-2006.

Big improvement over stock, revs up much faster! gets rid of that bottom end bog, Nice modification!
This is for a complete flywheel, it's never been installed since it was lightened, and there no need to send yours in.

No core charge!

In stock and .


*