Your cart is empty.
Your cart is empty.Backed by superior materials and rigorous testing, MOOG® sway bar bushings deliver reliable performance you can count on. MOOG problem-solving innovations ensure fast, hassle-free installation.
Customer
Reviewed in the United States on March 20, 2025
Easy to install, hard to tell in pic but yes it is split for install. Notched design as original part keeps it securely in place.
Tyler Boquist
Reviewed in the United States on February 7, 2024
Always make sure you measure your stabilizer bars and see what size they are using a caliper tester. Mine fit perfect and I was happy with what I got.
dan gelinas
Reviewed in Canada on July 2, 2023
Good fit no issue
Rather B. Fishing
Reviewed in the United States on November 10, 2023
We bought to replace factory PT Cruiser bushings that were worn out. This was the second PT Cruiser we installed the same bushings into and our experience with both is positive. Bushing was an exact fit. Very noticeable improvement in sway reduction with new bushings and sway bar links. We recommend these bushings. If you do not have a PT we hope your experience is positive like both of our experiences.
Jorge V.
Reviewed in the United States on August 1, 2022
Good value for the part. Installation was simple.
Gary Debodt
Reviewed in Canada on May 21, 2022
We're great for a bit then same noise is back. Proper size, lubed as instructed, slit in bushing to front of car and they are black not blue. Overall would not buy again or recommend
C. Earnshaw
Reviewed in the United States on August 5, 2021
Took all of ten minutes to install both sides on my PT Cruiser. Just jacked the front of the car up and put it on jack stands, loosened the rear sway bar brackets, slipped off the old bushings and slip on the new. These have a cut in them to slip over the bar (as did the factory bushings) so no need to disconnect the end links. I just did one side at a time (but loosening the bolts on the opposite side) so that the bar wouldn't fall down. Just took a little prying with a pry bar to pull the sway bar down enough to slip the new bushing on. I put a little silicone grease on the inside of the new bushings prior to installing them.
gton510
Reviewed in the United States on August 6, 2020
What is not to like? Works great.
lorne rielly
Reviewed in Canada on July 21, 2019
Wrong size not usable
A.J.
Reviewed in Canada on October 14, 2019
It fits my 05 neon
roger young
Reviewed in the United States on August 19, 2018
Perfect very pleased
Daniel Morin
Reviewed in Canada on June 4, 2018
Merci
MichaelJ
Reviewed in the United States on April 11, 2014
The Cruise I put these in is a 2006 and has 128k miles on it. I'm pretty sure the bushings I replaced were the originals, and they were pretty deformed. These went in without a hitch (along with new control arms) and the front end is much tighter and all the squeaking I had is gone. You can replace these without having to remove the sway bar, just loosen the brackets enough to push the old out and the new in. Make sure you put the openings forward.Struts are next!
Recommended Products
$24.67
$ 10 .99 $10.99