Shopping Cart

Your cart is empty.

Your cart is empty.

Motor Drive Control Board H Bridge DC Stepper Module 10A Peak 30A Motor Driver Controller Board

5.0 Write Review
Free shipping on orders over $29.99

$20.71

$ 8 .99 $8.99

In Stock
  • The drive uses the full two half-bridge driver chip + low N-channel MOSFET components. Completer two half-bridge driver chip drive mode, the MOSFET switching losses to a minimum. Improve power utilization.
  • This drive also has a brake function can be quickly stopped the motor, brake quickly, braking obvious, easy to implement this feature.
  • MOSFET driver chip comes with hardware brake function and power feedback. The driver can operate at 0-99% of the duty cycle of the PWM modulation, the motor driving voltage can be obtained sufficiently.
  • N-channel MOSFET IRF3205 MOSFET, use two dedicated half-bridge driver chip on the top tube using the boostrap capacitor, so that the tube has enough drive voltage of the MOSFET channel can be opened quickly, improve motor acceleration curvature, but also quickly for the motor brake. This allows the trolley can quickly start can quickly kill the car.
  • The driver focus on current and efficiency, effectively motor power and battery life. Can withstand high current overload, the maximum current up to 30A.


Product Description

1

2

Specifications:


Motor forward: DIR = 1 PWM = PWM


Motor reversal: DIR = 0 PWM = PWM


Parking brake: DIR = X PWM = 0 (X is an arbitrary state)


Motor and power connections


POWER connected to the positive power supply, GND power supply is negative. Two motors were connected MOTOR1, MOTOR2

Rated voltage: 3v-36v (can be customized according to the user)


Rated Current: 10A


Peak current: 30A


Size: Approx.108*58mm/4.3*2.3in(L*W)


Package List:1*Dual Motor driver module board H-Bridge DC MOSFET IRF3205 3-36V 10A

3

4

5