Shopping Cart

Your cart is empty.

Your cart is empty.

RadioMaster RP2 V2 2.4ghz ExpressLRS ELRS Nano Receiver

5.0 Write Review
Free shipping on orders over $29.99

$21.99

$ 10 .99 $10.99

In Stock
  • The RadioMaster RP series receivers are built-in a TCXO (temperature-compensated crystal oscillator) now, which ensures reliable, stable, and accurate signal reception, allowing for superior performance in demanding environments and enhancing the flight experience.
  • The RP2 V2 2.4GHz ELRS nano series receivers are open-source receivers based on ExpressLRS. The Nano receivers, first developed by Jye Smith from the ExpressLRS development team, feature ESP8285 MCU and SX1280 RF chip. The RP2 V2 has a built-in ceramic antenna which is super light and small in size and ideal for racing.
  • The RP2 V2 feature WIFI built in so you can upgrade firmware by WIFI and configure the Receiver via the built-in WebUI with your PC or mobile phone.
  • Due to the low-latency and high-refresh-rate RF module, the RP2 V2 is ideal for FPV races or Long Range. Suitable for many models due to the ultra-light and Nano size, these receivers can fit just about anywhere!
  • Compatible with all 2.4GHz ExpressLRS modules and transmitters with built in 2.4GHz ExpressLRS


Features
Improved PCB design is better for heat dissipation.
LED on the top side of PCB.
Solder pads are improved and easier to solder to.
Built-in a TCXO (temperature compensated crystal oscillator)
Compatible with all 2.4GHz ExpressLRS modules and transmitters with built in 2.4GHz ExpressLRS
Specification
Item: RP2 Nano ExpressLRS 2.4ghz Receiver
Type: ISM
MCU: EPS8285
RF Chip: SEMTECH SX1281
Telemetry RF power: 10mW
Antenna: On Board SMT Antenna
Antenna: 65mm 2.4ghz T Antenna
Frequency Range: 2.404 - 2.479 Ghz
Maximum receive refresh rate: 500Hz/F1000Hz
Minimum receiver refresh rate: 25Hz
Working voltage: 5v
Weight: 0.55g (On Board antenna)
Dimension: 13mm*11mm*7mm
Firmware Version: ExpressLRS v2.4 pre-installed
FW Target: RadioMaster RP1/2 2400 RX
Bus interface: CRSF
Package Includes
1 * RP2 ExpressLRS 2.4ghz Nano Receiver
1 * User Manual
1 * CRSF wire