Your cart is empty.
Your cart is empty.Innovative engineering, manufacturing technology and quality control ensure that Spectra Premium HVAC heater cores meet or exceed the performance of the original equipment they replace.
MANGO
Reviewed in the United States on May 21, 2025
Purchased this June 2024. Started leaking today. I remember it being a little too tall making the metal backing cover bulge out where it was making contact with the heater core. The ports did not line up with the factory holes either and needed to be bent to fit.
David
Reviewed in the United States on November 10, 2021
Fit in my 87 Wrangler Perfectly. Making heat
Travis Corkery
Reviewed in the United States on August 3, 2019
New heater core works great. I pulled the weather stripping and bracket off of the old one to make it fit better. I guess you wouldn’t have to do that if you didn’t want to, but it was so easy to do that I didn’t even think about it. Replacing the bad one took about 2 hours, but I kept a leisurely pace and had a few beers while I worked. Probably could’ve done it in 45 minutes if I hurried.
Tyler
Reviewed in Canada on May 6, 2019
Easy install. Works well
Customer
Reviewed in the United States on November 2, 2019
Just installed in my 1994 Wrangler. Good quality product 3 months so far no issues at all
Chris
Reviewed in the United States on March 20, 2018
It replaced the original perfectly, fit well. No complaints.Other than how much of a pain in the But to install(not this products fault, Chrysler’s fault.)
K. Rayman
Reviewed in the United States on February 5, 2018
Fit perfectly. Even had the foam rubber cushion so I did not have to use my old one. Great price as this costs twice as much locally at the big box auto stores.
LuvzPrime
Reviewed in the United States on April 4, 2018
Fits. I assumed that it would have the same brackets to bolt to inside heater core housing. Used some insulation tape so it wouldn’t rattle in the housing and form a leak. But I was able to install it and it seems to be performing its fuction
Dan O Earle
Reviewed in Canada on July 30, 2015
This rad lacks the plate that allows it to be secured in the heater box. It fits, and works, but the securing bolts from the OEM cannot be used
Ben Thomson
Reviewed in the United States on December 26, 2013
There is no attaching bracket so I put silicon on the top to bond it to the housing lid. This will make it harder to remove the lid in future. The gap in the top (shown in photo) allows air to bypass the core. I should have used duct tape/weatherstripping to close it. There is no weatherstripping on the bottom like the stock one so it is a very loose fit in the housing. I hope it does not rattle over time and work harden the tube welds resulting in cracks. I should have put weatherstripping on the bottom. Right now its tight due to compression by the housing against the firewall/seal around the tubes. It's a good price but if you have the money I would buy from the dealer.
Recommended Products
$76.95
$ 34 .99 $34.99