Your cart is empty.
Your cart is empty.titaniumrx
Reviewed in the United States on April 7, 2025
I didn't know it, but these knurled, brass low-point caps are just what I needed. My TT's low point drains needed a wrench to be removed. The factory hex caps were overtightened and also had thread sealer on the pipes. After breaking them free and cleaning the threads, I could install these new caps. These have a silicone gasket inside and the knurls make it possible to get a leak-free connection with just finger tightening.
Treadstone
Reviewed in the United States on April 24, 2025
These fit the low point water system drain lines on my RV perfectly. The old ones were made of plastic and cracked, spraying water everywhere. Being brass, I expect years of use out of these. They are high quality and the knurling on the outside makes it easy to screw on without tools. It has a washer inside to make a perfect seal. I recommend these.
Actual PhD
Reviewed in the United States on April 2, 2025
My RV had mismatched plastic drain caps due to one breaking and being replaced. These are solid brass attractively finished. While the drain caps are not something that is a key to the looks of an RV, they are visible and these will certainly last unlike the cheap plastic ones the camper came with. As a former Harley owner, I am into upgrades.
Not mario
Reviewed in the United States on April 2, 2025
My old plastic drain caps are starting to look worn and brittle. These should replace them nicely and should last the lifetime of my camper. They look just like pictured in the listing and seem to be of good quality.
William A. Nolan
Reviewed in the United States on April 17, 2025
These are nice bright brass caps and they certainly dress up the low point drains. Of course, I still have PEX pipe coming into a fitting that these screw onto. They are nice and they even have a curved washer that seals it up nicely.
A Ford
Reviewed in the United States on April 10, 2025
Well manufactured brass Low Point Hot/ Cold drain caps with new seals. These were manufactured with high quality in their design, thread forms and ease of use. These brass caps are a higher luster, well made and look to last a lot longer than the typical plastic designs. The inner seals were also of a higher quality. One thing I liked the most was the knurled OD of the cap, allow finger tightening without the need a of a second wrench.
Recommended Products