Your cart is empty.
Your cart is empty. 1. Operating voltage: DC 12V-36V
2. Operating Current: 3. Driver Power: 4. Speed Voltage: 0.1V-5V
5. Operating Temperature:-40-85°C
Specification:
Description:
Brand New &
Specification:
Operating voltage: DC 12V-36V
Operating Current: Driver Power: Speed Voltage: 0.1V-5V
Operating Temperature:-40-85°C
Humidity: 90%RH
Stall :Yes
Enable Control: Yes
Over-current : Yes
Steering control: Yes
Speed control : Yes
Size: 63*42*17mm(L*W*H); Probe size 3mm,length: fixing hole center distance 57mm; width:fixed hole center distance 36.5mm
Power terminal Out:
VCC(positive power supply)
GND(negative one)
MC(motor phases W)
MB(motor phases V)
(motor phase U)
Set for the control side:
GND control terminal ground
VR the governor end 0-5V(corresponding to 10% of motor speed -)
reversing control(connected to 5V or ground can the motor rotation direction)
M tachometer pulse output(depending on the number of motor poles corresponding to the number of pulse per revolution of the output number)
EL enable control terminal(connected to 5V ot ground running then 5V, grounding the motor stops)
5V 5V control terminal
HALL for the hall terminals:
5V Hall power positive
Ha Hall
Hb Hall
Hc Hall
GND Hall negative
Wiring:
Control terminal for SET:
1. The motor speed control wiring methods: available potentiometer system speed can also be connected to the MCU control, when the potentiometer control wiring, the potentiometer middle pin is connected to VR speed port, potentiometer connected to both ends of 5V and GND terminal voltage more high speed faster.
2. Motor steering control wiring methods: you can switch control can also be connected to the MCU control, to GND in one direction, then in 5V.
3. Pulse speed : high and low output . IC can not understand the information with the
$117.28
$ 49 .99 $49.99
$169.79
$ 80 .99 $80.99