Your cart is empty.
Your cart is empty.
Hydraulic fan is the fan between oil-bearing fan and ball bearing fan. It is cheap but with long life and the advantages of quiet fan. In a word, it is a highly cost-effective product.
Specification:
Model: 4010 hydraulic bearings fan
Rated Voltage: DC 12V/24V
Operation Voltage: DC12V-26V
Consuming Current: 0.05A+5%
Consuming Power: 1.2W
Max. Air Flow: 6.0CFM
Acoustic Noise: 24.4dBA
Rated Speed: 5000±5%RPM
Connector: 2pin-ph2.54
Life Expectance: 40,000 hours
Size: 40x40x10mm
Polarity Protection:
1. When Vcc and GND are reversely connected, there is no conduction.
2. When Vcc and GND are reversely connected, the circuit board will not be burnt if pulled out in 5 seconds.
Package Including
4 * 4010 12V/24V fan
Brandon
Reviewed in the United States on September 5, 2024
I used these for my 3D printer. I had to cut the ends off but they work great. They actually are quieter than stock fans as well which is nice. Definitely recommend.
Muy buen producto
Reviewed in the United States on May 19, 2024
Excelent product just make sure to select correct Voltage
Robert Pridgen
Reviewed in the United States on March 14, 2024
Performed exactly as anticipated.
Michael Cortez
Reviewed in the United States on October 2, 2024
All do not work connected and no response I’m not sure if it’s a defect or anything I recently purchased the 12v from seller and all those work I’m not requesting a refund because of the price being low but come on really I had some expectations but none were met
William Jones
Reviewed in the United States on January 3, 2024
Fan has worked well. The LED functions look really cool as well. Can't say they work better than anything else, but for exposed/visible fans the rgb effect adds a nice look.
Julián Patrón Rodríguez
Reviewed in the United States on April 4, 2024
This fan should not be used for 3D printers as it does not provide enough cooling compared to the original printer fans. The original fans operate at 7,000 RPM, while this fan runs below 4,000 RPM, which is insufficient for cooling during 3D printing.Although I have to say, they look pretty nice.
FDP
Reviewed in the United States on November 26, 2023
These seem well made and I like that they come with connectors pre-crimped. A definite time-saver. The price is good, although the packaging is a bit meh. These come tightly packed side-by-side in a zip lock bag. Even a piece of cardboard on either side to protect the fan blades would be a significant improvement. Mine arrived in good condition but I could see these being easily broken in transit.
Shelby McMillan
Reviewed in the United States on November 18, 2023
The media could not be loaded.
Recommended Products
