Your cart is empty.
Your cart is empty.Product Description
Replacement or installation method
Burner Assembly Replacement Steps:
1. Turn OFF power to the refrigerator. Close the LP gas tank valve. Close the combination gas control valve manual shut- off.
2. Remove the drip cup. Remove the burner box cover.
3. Use two wrenches to loosen the flare nut connecting the gas tube to the burner assembly.
4. Remove the burner assembly retaining screw.
5. Remove the burner assembly from the burner box frame.
6. Install the new burner assembly. Do not overtighten the retaining screws of the burner assembly.
7. Connect the gas tube to the burner assembly, first tighten the flare nut by hand, then finish tightening using two wrenches.
8. Install the burner box cover and drip cup. Do not overtighten the retaining screw.
9. Open the LP gas tank valve. Open the solenoid gas valve manual shut- off.
10. Turn ON the refrigerator and select LP manual mode operation.
11. Leak test LP gas connections during the 30 second trial-for-ignition.
Customer
Reviewed in the United States on April 12, 2025
Installed this LP Burner after replacing the cooling unit on my N641 refrigerator. This burner does not regulate the flame well and after so many cycles, the refer throws the "N" code and shuts down. The slots cut into it where the flame comes out are cut too long so the flame/oxygen mix is not right and the flame doesn't get high enough to burn into the stack.Had to replace with one from JC Refrigeration that works and too late to ship this thing back for a refund. Cannot recommend this for a Norcold model 641 and not happy that I can't return this for a refund.
Charlie
Reviewed in the United States on September 14, 2024
This burner assembly is a no nonsense, direct replacement burner unit. I did have one issue with my frig and that was the supply line was an older style line and had to be replaced but, that is a very simple fix should you have an older frig as I do. I highly recommend this unit if you need to replace the burner assembly in your frig.
Paul Goodwin
Reviewed in the United States on February 5, 2024
When you get a part that the manufacturer tells you is no longer available - don't give up ! Try other places. In my case - Amazon. Yes they had this for my RV fridge, yeah !
Mariano Valle
Reviewed in the United States on February 19, 2024
You need to push the wire into the black socket block. They clicked but weren't installed securely enough so when I put the burner back in place they slipped out of place. The wires should already be assembled into the module to avoid this.
Ginger
Reviewed in the United States on February 11, 2024
Needed this part to repair our RV. The line came when promised and arrived in good condition. That said, I do not recommend trying to fix a damaged gas line unless you know what you are doing.
Michael J. Shipione
Reviewed in the United States on November 18, 2024
Ordered this burner for my Norcold refrigerator. Fit perfectly and was only about 15 minutes to change.
Sidney Brown
Reviewed in the United States on April 13, 2024
This part which is a replacement for the Norcold N621957 fit perfectly and has the correct orifice size. The orifice size is important because a orifice that is too small will not allow the refrigerator to cool down all the way. Another burner that was listed as a replacement for the N621957 did not work because the orifice was too small. The burner with the too small orifice was from Hihitomorrow. The correct orifice size is .016 inches. I deducted one star because the end fitting adapter could not be removed from the burner tube without potential damage to the tube.
Recommended Products