Your cart is empty.
Your cart is empty. Model: ibt-2
Input voltage: 6V ~ 27V
Maximum current: 43A
Input level: 3.3V ~ 5V
Control mode: PWM or level
Duty cycle: 0 ~ 100 percent
Current conditioning output: Yes
Terminal Wiring Instructions
1.Prwm : forward level or pwm signal input, high level valid
2.Lpwm: reverse level or pwm signal input, high level valid
3.R_ En: forward drive enable input, high level enable, low level off
4.L_ En: reverse driver enable input, high level enable, low level off
5.R_ ls: forward drive side current alarm output
6.L_ ls: reverse driver side current alarm output
7.VCC: + 5V power input, connected with 5V power supply of MCU
8.GND: signal common ground terminal
Wiring Instructions
Methond 1:
VCC is connected to 5v power supply of Mcu, GND is connected to GND of MCU.
R_ EN and l _When en is short circuited and connected to 5V level, the driver can work.
L_ PWM, input PWM signal or high level motor for ward
R_ PWM, input PWM signal or high level motor reverse
Methond 2:
VCC is connected to 5V power supply of MCU, GND is connected to GND of MCU.
R_ EN AND L_ EN short circuit and input PWM signal for speed regulation
L_ PWM, pin input 5V level, motor forward
R_ PWM, pin input 5V level, motor reversal
ben
Reviewed in the United States on March 8, 2024
I've used these before this seems to be a bad batch.They lock up using 24V (yes I've used these in the past with 24V) and they lock up as if they have an overvoltage lock out
Recommended Products
