Your cart is empty.
Your cart is empty. Brand New Engine Oil Pressure Sensor with Crush Sleeve Gasket and Wiring Harness Pigtail
Compatible with Select numerous GM vehicles, View compatibility chart to verify your specific model
Replaces ACDelco D1846A or 12616646 12573107 12569323 12562230 12614969
Typically Solves DTC Diagnostic Trouble Code PO520, PO521, PO522, PO523, PO524
It Is Very Important To Change Your Oil At The Recommended Intervals Spelled Out In Your Owners Manual. Failure To Change The Oil At Recommended Intervals Can Lead To Numerous Engine Issues And Trouble Codes That Relate To This Sensor And Others Including Variable Valve Timing Issues
See Compatibility Chart To Verify Your Specific Vehicle Year, Make, & Model
⚠ California Proposition 65 WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Mario
Reviewed in the United States on January 6, 2023
Worked as intended.
Tonie Athill
Reviewed in the United States on February 16, 2022
changed and oil pressure low engine code still apears and goes away and then comes back and beeps the entire drive even after replacing and getting oil changed.
Brent
Reviewed in the United States on June 1, 2020
Sensor fit bit dont like the three green wires.
Corbin Karl
Reviewed in Canada on June 2, 2019
Works good
Amanda Culbertson
Reviewed in the United States on February 6, 2019
Price was good, but it’s no where near the quality of the oem or parts store part. Installed and the plastic broke clean off from the base when I plugged it back it. Spend a little more and save yourself the aggravation of changing this already hard to reach part again. You can see how much thicker the base is on the parts store model on the right.
Alex Pederson
Reviewed in the United States on August 21, 2018
Nice kit, and better price then local stores. Fit 2003 Silverado 5.3 vortec, good luck installing it though guy, right between cab and back of engine. Use a pivoting socket wrench to break the old one loose and be careful any old leaves or twigs don't fall in the new hole. A noice like me can do it though, and I'm about as stupid as they get so I'm sure you'll have no issues.Also my symptoms where an occasional clicking sound from stepper motor on gauge and fluctuating from full oil pressure to no oil pressure. After I installed the gauge said I had good normal pressure.
Barry Batterman
Reviewed in the United States on June 19, 2018
Installed on my C5 Corvette (2000) - worked like a charm. They said that you have to remove your intake manifold to get it past the firewall, but with a 1 1/16" socket, a swivel extension, and a long grabber it can be done with minimal removal of the smog lines. Must have long fingers though. ;)
Abrasive
Reviewed in the United States on March 14, 2018
Glad this sensor came with the new wiring pigtail. I thought my sensor was bad and turned out mice had chewed through the wires. I went ahead and put the new sensor in and it works great after splicing on the provided plug. Been in for a few months and working great.
Shawn H.
Reviewed in the United States on April 23, 2017
This kit came with a new sensor, wiring harness, and butt connectors. This fit perfectly on my 03 Suburban and works properly. I didn't need the harness, but it's nice to have in case. Before, my oil pressure was maxed out at 80 psi on my gauges and now it's reading properly around 35 psi.
Recommended Products
$105.99
$ 45 .99 $45.99