Your cart is empty.
Your cart is empty.Vehicles with automatic transmissions have a flex plate. The flex plates connects the engine and transmission. Most flex plates are made of a thick piece of sheet metal with bolt holes for the torque converter and teeth for the starter. The job of a flex plate is to allow for expansion of the torque converter as engine RPM increases. The constant expansion and contraction of a flex plate over time can result cracks and/or shearing of the flex plate. A damaged flex plate can create serious (expensive) damage. Broken flex plates can not be repaired, they must be replaced. ATP flex plates are made of high quality steel and contain the correct bolt hole spacing and ring gear teeth just like the original part to ensure long life and durability
Stockwell45
Reviewed in the United States on March 11, 2025
Good replacement for the stock flex plate on the 400 in my 78 bronco. 100 miles and no issues
Nate Spears
Reviewed in the United States on October 21, 2023
This product does the job. It's a flywheel/ flexplate. Not a whole lot going on there. Lol.
Papa and Mama Bear
Reviewed in the United States on February 16, 2019
it was pretty inexpensive. My start scrubbed on the flex plate so I had to use heavy duty washers to back space my starter about 1/8-1/4 inch and after that it was a perfect fit. it is the correct flex plate for my vehicle just something a little off btw it and the replacement starter. Gave it 5 starts bcs it works perfectly, the spacing issue may be the autozone starter...
S. Vincent
Reviewed in the United States on January 6, 2016
Here you go, ATP product again, this is high quality and the finish is top notch. This product was a small fraction of others made for the same purpose and excellent quality.I would buy ATP products again.
Recommended Products
