Your cart is empty.
Your cart is empty.Vehicles with automatic transmissions have a flex plate. The flex plates connects the engine and transmission. Most flex plates are made of a thick piece of sheet metal with bolt holes for the torque converter and teeth for the starter. The job of a flex plate is to allow for expansion of the torque converter as engine RPM increases. The constant expansion and contraction of a flex plate over time can result cracks and/or shearing of the flex plate. A damaged flex plate can create serious (expensive) damage. Broken flex plates can not be repaired, they must be replaced. ATP flex plates are made of high quality steel and contain the correct bolt hole spacing and ring gear teeth just like the original part to ensure long life and durability
Miguel Mata
Reviewed in the United States on November 29, 2023
My mechanic installed and has been doing finr
aaron
Reviewed in the United States on January 2, 2021
I was sent a used flywheel... USED! unbelievable.
Curtis S. Jones
Reviewed in the United States on January 25, 2020
I like the product but I ordered the wrong one
Matthew
Reviewed in the United States on April 28, 2017
Garbage. Appeared used vehicoe does not run correctly
jjohnson
Reviewed in the United States on September 9, 2016
Garbage installed 200 miles later the teeth started busting off
Tha dope1
Reviewed in the United States on January 29, 2016
It works, came on time.
R. J. Gizzi
Reviewed in the United States on August 24, 2015
Flywheel poorly manufactured.Spacing on crank sensor windows incorrect.Vehicle would barely run and constantly set crank sensor codes.Went to junkyard and purchased a used O.E. Jeep flywheel and installed it.Problem solved.Wasted countless hours because of this.Learned my lesson.Buy O.E. only for this application.
Recommended Products
