Your cart is empty.
Your cart is empty.Rugged, Attractive, and Affordable Case for Eurorack Load up your favorite Eurorack modules into the robust and eye-catching Eurorack Go case from Behringer. With a generous 240HP of mounting space, the Eurorack Go is perfect for holding Behringer’s impressive line of semi-modular synths, System 100 and System 55 modules, and third-party Eurorack units. Synthesists at Sweetwater agree: Eurorack Go’s chassis looks great in the studio, and it’s entirely road-ready. Instead of pre-dilled rails, the Eurorack Go comes equipped with 96 sliding nuts, so you won’t have to fight to get your modules to fit. Do you prefer your Eurorack case flat or elevated? The Eurorack Go lets you have it both ways, with an adjustable back leg that holds the chassis at a 50-degree tilt. The Eurorack Go is also packed with power, delivering 32 keyed powered connectors driven by a hefty, low-noise power supply. Looking for an affordable Eurorack
Dacques Viker
Reviewed in the United States on June 8, 2024
Perfect addon for my Behringer 55 rack. Solid power supply and expansion bus. Some people have complained about it being too shallow but I have not had a single module that did not fit, Plan on buying another one soon.
devtank
Reviewed in the United States on November 21, 2024
I’ve had a few modular systems, and always built a wooden case, 4MS power, Meanwell 90w brick, square nuts, rail etc etcRack rail is expensive; 4x140 strips would cost well over $120 on Etsy prices alone. So this thing is a game changer: huge balanced power supply, space for two complex pathways, and a solid well designed case that you can carry short distances, and a stand that makes the unit small on your desk.
Fred Rayworth
Reviewed in the United States on April 12, 2024
This 2X140 HP Eurorack Case from Behringer was an outstanding buy. It’s nice and solid with a more than adequate power supply. The rails contain captured nuts and each module I bought came with the screws. It was just a matter of sliding the nuts into the approximate position and getting the screws to catch. It became a bit trickier toward the end of the row where all the excess nuts accumulated. However, I still managed. Also, the further down you get in the row, the more cramped and difficult it is to attach the power cables. Luckily they were a great fit and snapped right in with a little maneuvering and I completed both racks with no issues. I love it. Highly recommended.
reg noms
Reviewed in the United States on March 28, 2022
Behringer states: "Designed for rugged reliability, the all-aluminum chassis houses an adjustable support plus oversized rubber feet to provide 0-50° setup capability and ensures rock-solid stability for use on a wide range of surfaces."IT IS PLASTIC!!The sliding nuts aren't great, can be a hassle as they don't provide nearly enough.It's very shallow so only some module fit.But it is PLASTIC not aluminum as Behringer claims.
J. Bragg
Reviewed in the United States on March 13, 2022
This is an excellent case for the price. Roomy, plenty of power, and reasonably priced in comparison to other options. I will definitely be buying more of these as I expand my modular synth setup.The only caveat I would offer is that it would not be great if you intend to fill it mostly with slimline/pico modules, as you may run out of nuts to install modules and/or power sockets.
Puddelglum
Reviewed in the United States on August 19, 2021
It's huge, it comes with a ton of power, it can be arranged standing or flat, and it's affordable!Sure Intellijel and other cases look sexier, but their 2x104 hp offerings give you much less space at double the price.
Eric Jolliffe
Reviewed in the United States on March 10, 2021
This might be a “budget” eurorack case, but I cannot find any fault with it.140hp x 2 rows, sliding nuts (which actually makes for very easy readjustment if you’re using modulargrid.net to plan out your kit)High output power supply(+12 V @ 3 A, -12 V @ 1 A, and +5 V@ 1 A)Included sturdy, solid aluminum, rubber-footed kickstand for angled usage, grippy rubber feet for flat usage.The outer case/body -is- plastic, but it seems to be some kind of high impact/reinforced durable plastic material.It looks great, is easy to work in, and doesn’t feel cheap or flimsy. A great value and a quality product from my (physical eurorack beginner) perspective!
TaFT
Reviewed in the United States on October 21, 2020
Perfect deal brand new. Works well and holds two 70hp Behringers and my digital setup.
Recommended Products
$27.90
$ 12 .99 $12.99
$189.00
$ 93 .99 $93.99