Shopping Cart

Your cart is empty.

Your cart is empty.

CE Smith Tail Light Protector

Free shipping on orders over $29.99

$28.71

$ 12 .99 $12.99

In Stock
  • Ce Smith Tail Light Protector
  • Height 5-3/8" Inside dimension, Width- 5-5/16" Inside dimension, Depth- 3" Inside dimension
  • Bottom is cut out for license plate illumination
  • 2" (measured on center) mounting holes fit standard DOT brake/tail lights.
  • Mounting hardware or tail light is not included.


Tail Light Protector adds protection for fragile trailer tail lights. Mounts between the existing tail light mounting brackets and the lamp using the two lamp mounting studs. Mounting holes fit standard DOT brake/tail lamps. No hardware required for installation. Aluminum tread 0.080" thick.


Customer
Reviewed in the United States on February 10, 2021
Works exactly as I hoped it would.
jay white
Reviewed in the United States on December 16, 2020
These look really nice but they are a little on the light side. I wished they were made of thicker/heavier gauge metal.
Brad R. Adams
Reviewed in the United States on November 22, 2020
There was no mention of this only being one item and not a pair. High priced for each. Quality is good though.
CB03
Reviewed in the United States on May 20, 2019
Price is for 1. Ordered 2 for my new utility trailer. Installed them both easily in about 5 minutes. Good quality & good looks. They are a little thinner than expected, but should do the job of protecting lights against LIGHT impacts.
Jacob F.
Reviewed in the United States on December 24, 2019
It's winter, and the trailer is in my garage, stuck there until the snows melt and the sun comes out before I can install the light guards on the trailer because the tail-lights are against a wall until then. From the looks of the product, they look like they will do a great job from minor to medium hits, but in the event, a logging truck decides to rear-end my trailer, they will hold up just fine, doing their job 24/7. Good looking product!
Electrohacker
Reviewed in the United States on August 11, 2017
Had to flip my plate holder and remove one set of nuts on the drivers side (side with the plate holder) Otherwise install went really smooth
David Martz
Reviewed in the United States on June 24, 2017
They added a nice look to the back of my boat trailer
G.Krause
Reviewed in the United States on January 22, 2017
Wow!! Shipped so fast!! Awesome product arrived in great condition! Very Happy! THANKS!!!
Recommended Products

$21.25

$ 8 .99 $8.99

4.6
Select Option

$49.99

$ 23 .99 $23.99

4.5
Select Option