Shopping Cart

Your cart is empty.

Your cart is empty.

DC 12V Four Wire Thermostat PWM CPU Fan Temperature Control Speed Controller Governor Module for PC

5.0 (2) Write Review
Free shipping on orders over $29.99

$10.63

$ 5 .99 $5.99

In Stock
  • The controller only controls the speed of the all standard four-wire chassis fan and CPU fan for
  • It integrates manual speed regulation and automatic temperature control and speed regulation function
  • Accurate temperature setting and control
  • When the temperature lower than the accelerated temperature, then output at the minimum rotation speed; when it exceed over the full temperature, then always output at full speed
  • When the corresponding open channel fan break down, the controller will alarm with sound and light (works with buzzle), alarm will automatically eliminated when the fan is rotated recovery


Product Description

GS06778-1

DC 12V Four Wire Thermostat PWM CPU Fan Temperature Control Speed Controller Governor Module for PC

YT


The controller only controls the speed of the all standard four-wire chassis fan and CPU fan for


Accurate temperature setting and control


It integrates manual speed regulation and automatic temperature control and speed regulation function

1

GS06778-2

GS06778-3

1

GS06778-2

GS06778-3


Note:


Please note that the controller is a four-wire PWM fan controller can control four-standardized protocols in line for 's four-wire fan (all four lines of the chassis and CPU fan are met, a server with more than 97% can control fan violence). Unable to control two-wire or three-wire fan, you can not completely turn off the fan!


BF1, BF2 (No.4,5) correspond to FAN1, FAN2 stop alarm function switch. When the corresponding open, the controller will sound (with buzzer needed) and light alarm, fans restored after the alarm is cleared automatically rotated. If BF1 and BF2 are open (ON), the FAN1, FAN2 have any one or two stops, the controller will alarm.


Not for: FFR0612VHE, FFR0612DHE, Dimensions 6038, Non-standard anti-timing fan (reverse adjust speed)



Specification:


Board Size: Approx. 5.3*4.5cm/2*1.7inch


Positioning Hole Position: 44*37mm/1.7*1.5inch


Positioning Hole Diameter: 3mm


Operating voltage: DC12V


Circuit Load Capacity: Maximum current per output 4A, the bus currents up 9A


Output Range:


The First Channel: or (TFL=ON)


The Second Channel: 10% -


The Third Channel: 10% -


Temperature Probe Parameters: 50K B=3950


Thermostat Temperature Zone Error: Generally 3-5% (Depend on the temperature probe)


Stall Alarm Minimum Speed: 700-800 rpm


Weight: Approx. 17g / 0.6oz



Function Setting Switch Description: (Any changes to the setting must be repowered to start before it takes effect)


TFL (No. 1): PWM channel with the lowest temperature setting, when ON, the lowest PWM of FAN1 is 40%; when OFF, the minimum PWM of FAN1 is 20%


TP1 and TP2 (No. 2 and 3): Temperature channel control temperature zones are interpreted as follows (need to match the temperature probe used):



Package List:


1 x PWM Fan Speed Controller


1 x Buzzle


1 x Probe




A. M. Williams
Reviewed in the United States on August 8, 2024
The controller does not wait for the fan to spin up until it starts beeping. For my intended purpose, to replace a refrigerator fan that cycles on and off, this makes it useless since every time the fan is powered on it will beep a couple of times. Most fan controllers have a 2 second delay to wait for a fan to spin up before beeping;
Greywolf
Reviewed in the United States on July 4, 2024
This product works great for regulating the speed of the cooling fan for my 44cc Cison OHV V8. I also use one on the 44cc Cison Flathead V8 as well. Thanks.