Your cart is empty.
Your cart is empty.Product Description
Hiroshi Tomita
Reviewed in the United States on May 9, 2025
Doesn’t fit 250’ roll of wood edge banding. Unable to keep edge banding lined up with the work piece. On the latter point, I could be using it wrong despite my best attempts to follow the instructions.EDITProduct is working well. Set the grey moving jaws so they are just a hair wider than the edge banding. The black spring loaded clamps will be set to the widest possible setting and seem impossible to fit over 3/4" plywood but it will wiggle on. I have been clamping the plywood to the table laid flat, turning on the heat gun, wiggling the black pads over the pIywood but not yet fully pressed onto the plywood, feeding the edge banding in, then pressing the weighted roller and edge banding to the plywood and rolling it on. Sometimes you need to hold the strip so it doesn't slip. I am using pre-finished maple edge banding and setting it to between 400 and 470 on the dial and that is a good heat for minimal warm up time and rolling it on at a decent pace.ConsStill doesn't hold 250' rolls of edge banding. Measure out and cut strips from the roll until it fits. Manually feed the strips into the heat gun.The weighted roller is not centered properly and rubs the side of the housing which makes the heat gun catch and "jump" when rolling on edge banding.
Recommended Products