Your cart is empty.
Your cart is empty.Elgin Pro stock high performance stainless steel roller rocker arms for Chevy Big block. 1.72: 1 ratio with 7/16" stud diameter. Set of 16 rocker arms and poly locks.
Jason Child
Reviewed in the United States on March 15, 2025
So far so goodThey have seen some revs and seem to be very good
Randall Coleman
Reviewed in the United States on March 15, 2025
Very well built
JEREMY
Reviewed in the United States on July 1, 2023
I don't think I would use these on a solid roller. I would spend the extra money on a different brand for a solid roller.
Ron D.
Reviewed in Canada on July 18, 2022
These MAY be O.K. for stock (low valve spring pressure) only. Poly locks are junk!The mating face on the lock is actually made very narrow to match the narrow receiving area of the rocker. Will not last with the spring pressures they say they are good for. Quality poly locks and locks for stud girdles will not fit this terrible design! Buy only if you have stock or low pressure valve springs.
r. becks
Reviewed in the United States on January 11, 2022
very cool for the cost. similar to a discontinued cc rocker. also close to an old enduro rocker from cr. iv'e run both. this is a super choice for a street car. dont waste the money on "roller tip"rockers boys and girls. they are 'heavy' in hand but balance is good. good bet for sure.
Smokey
Reviewed in Canada on August 19, 2019
Exactly what I needed at a fantastic price.
austin w.
Reviewed in the United States on December 4, 2019
Used them in my 1990 tbi454 mark IV motor with a new cam and comp cam rods. Once adjust, prelubed etc they have been working flawless
Recommended Products
