Your cart is empty.
Your cart is empty.The affordable and flexible solution for installation and repair of your Equus mechanical oil pressure gauge. This 6 ft. nylon tubing kit includes all new 1/8 in. brass compression fittings and a 1/4 NPT reducer bushing.
jsl
Reviewed in the United States on September 3, 2024
Worked well
T. Smith
Reviewed in the United States on October 11, 2023
Great replacement for my boost gauge connection, perfect fit.
Jennifer
Reviewed in the United States on May 8, 2017
The Right part for the Right job , was just as advertised could not be happier i would recommend this when you need the right part
Jeremy H.
Reviewed in the United States on July 21, 2016
Works as advertised.
Linda Kuest
Reviewed in the United States on January 16, 2016
great job
Erik Pearson
Reviewed in the United States on October 2, 2015
it's a snap to run and setup. I used it as a temporary fix until I replaced the original sender/gauge. I wouldn't trust nylon for an indefinite period of time, as it will be subject to heat and deterioration- which may end up with hot oil spilling in the car.
Michael Binko
Reviewed in the United States on September 12, 2014
everything you need in one package.
kevz71243
Reviewed in the United States on May 17, 2014
Its ok if I had to do it over again id buy a metal tubing type. I was replacing the old line on my tractor it had dry rotted and some old storm tree tops I piled up broke it off while I was bush hogging around them. But anyways make sure u use some Teflon tape and don't!!!!! over tighten!!!! I did and it just bent the fitting flat and I had to tap it out of the block piece by piece!! lucky I still had the old brass fittings. I got it together after all said and done.
Recommended Products
$69.99
$ 31 .99 $31.99