Your cart is empty.
Your cart is empty. This is speaker wire to 3.5mm 1/8 inch trs stereo male plug jack connector adapter, bare wire pigtail replacement repair 3.5mm audio cable.
Wiring: PIN 1 - red wire is the left channel; PIN 2 - white wire is the right channel; PIN 3 - black wire is ground.
The 1/8 3.5mm to speaker wire cable is widely used in speaker, headphone, headset, earphone, subwoofer, amplifier, home theater stereo, Hi-Fi system, and more 3.5mm audio application.
The 3.5mm cable comes with pre-stripped and pre-tinned ends, it's very easy to be soldered and connected.
Package contents: 2-Pack 12 inch 3.5mm stereo male plug to bare wire pigtail speaker wire cord cable.
David Watts
Reviewed in the United States on March 23, 2025
Quality poor.
Customer
Reviewed in the United States on August 7, 2024
The product is just fine. It was my application that wasn’t right.
stephen caldwell
Reviewed in the United States on August 13, 2024
Built good.
BillW
Reviewed in the United States on August 1, 2024
Nice pigtail for Bose antenna.
Honscille
Reviewed in the United States on June 20, 2024
I only used one of these and it worked perfectly fine. No complaints.
larry lisle
Reviewed in the United States on December 20, 2024
Good quality, reasonable price, works fine. What else could i ask for?
Charles C Craig Sr.
Reviewed in the United States on October 19, 2024
Easy to use and easily replaced a broken plug in for my speakers.
snowman1
Reviewed in the United States on October 5, 2020
Update Oct 7, 2020 I have changed my rating to 4 stars due to the seller. While i got a defective product, the seller was quick to resolve the issue.Purchased this to replace the plug on my Klipsch 2.1 system. After 10 yrs the strain relief gave out. Precursor- I have been soldering electronics for 35 yrs.Wired and soldered the first plug and had static plus low volume level, figured ok got one that didn't have a properly soldered ground connection. Thought ok no biggie, I will just use the other one. Wouldn't you know it, same problem.Solution, went and purchased just the plug itself with no attached wires, soldered it up and now everything is working as it should be.So wasted $8 and my time because of what i would assume was a quality control issue. Guess that's what i get for not just buying the plug in first place. Going for the short-cut rout, did not end up being a short-cut in the long run. I understand no matter what the product is, it is inevitable that some dud's slip through the cracks. It's just a little aggravating for those who get the dud.
Recommended Products
