Shopping Cart

Your cart is empty.

Your cart is empty.

For Ford Mustang 8.8 Differential Cover Rear End Girdle System

4.3 (1) Write Review
Free shipping on orders over $29.99

$58.77

$ 26 .99 $26.99

In Stock
  • High quality, made of high-quality cast aluminum, lightweight but strong and corrosion-resistant, long service life, better protection of your car's differentials
  • Well-designed, forged craftsmanship, perfectly matched with the rear axle for better driving pleasure and safety performance
  • Fits 1979-2004 Mustangs with factory 8.8" rear ends, will fit 2005-current Mustang if you use a panhard relocation bracket (not included)
  • Includes all necessary hardware, including gasket and bolts, installs in approximately 30 minutes using basic hand tools (synthetic fluid recommended)
  • Package Includes:1 Differential Cover Girdle Assembly;1 Girdle Gasket;10 Flat Washers;10 Lock Washers;10 Cap Screws


Upgrade your Mustang's rear end with the Mustang 8.8 Differential Cover Rear End Girdle System . Constructed from high quality cast aluminum, this differential cover rear end is both lightweight and strong with excellent corrosion resistance. Forged to ensure a perfect fit in the rear axle, fits 1979-2004 Mustangs with the stock 8.8 rear end, and will also fit 2005-present Mustangs if you use a panhard relocation bracket (not included) . This girdle system installs easily with basic hand tools and includes all necessary hardware such as washers and bolts. Improve the performance and durability of your Mustang with this well-designed differential cover rear end girdle system.


jim moore
Reviewed in the United States on August 28, 2024
The supplied bolts were too long and bottomed out in the housing even with the supplied flat and lock washers installed. Had to remove 3 threads to bolt it down.The threads in the main cap screws are loose feeling. Lock down OK I suppose but definitely not a good tolerance. I used silicone on the threads and under the nuts to stop potential leaks.The lube fill plug is very high and if folks use it thinking it's "normal" to fill that high they will be way over full. Must use factory one in the housing.