Your cart is empty.
Your cart is empty.Product Description
Getting Started
With a few steps this 2003-2018 Dodge Ram 5.9L or 6.7L Cummins Transmission Cooler Line T-Fitting Adapter will be ready for use and you’ll have access to accurate readings directly from your trans temp source.
Cut the Cooler Feed Line
Measure 1-7/8” in the cooler feed line in a location between the bends. Use a pipe cutter to cut and remove the 1-7/8” section from the line.
Install the T-Fitting
Install the cooler line T-fitting female fittings over each end of the cut line. Then place the metal cutting rings over each end of the cooler line.
Thread in the Sensor
Install the 1/8-27 NPT temperature sensor into the port on the T-fitting housing. Be sure to wrap Teflon tape on the threads of the sensor to prevent leaks.
Who We Are
GlowShift is your source for cutting-edge aftermarket automotive products specially designed for cars and trucks. Our diverse lineup includes a variety of gauges, gauge pods, and gauge accessories such as adapters, sensors, wiring harnesses and much more.
myamaziname
Reviewed in the United States on January 5, 2024
Transmission tubing wouldn’t install on one end. Thought there was a problem with the tubing but realized one of the ferrules was cut too small. Went to the hydraulic supply down the road and bought a good connector. Yes it cost more but it’s a quality tubing fitting.
Kevin
Reviewed in the United States on January 5, 2022
Worked perfect for 2016 Dodge Hellcat Charger. It was very difficult to screw the temp sensor in though. I basically had to tap the t-housing threads using the sensor threads. It was like there was some kind of gunk in the t-housing sensor threads. Just take your time, keep your threads clean, add lube to threads as you progress, unscrew sensor, clean threads, repeat.
sonia
Reviewed in the United States on June 24, 2021
worked great, everything that I was hoping for, fit my 2001 dodge Cummins just fine.
Buddy Mickey
Reviewed in the United States on May 24, 2021
Easy install....worked on my 2007 expedition
Mark Beers
Reviewed in the United States on March 1, 2020
Went in easily and didn't have any leaks. Well worth the money.
Anthony David
Reviewed in the United States on February 6, 2019
Perfect fit with zero leaked
Customer
Reviewed in the United States on July 10, 2018
Worked super flawlessly! I have ruined other compression type fittings in the past by overtightening them so I was very leery. Make sure u clean the tubing with fine steel wool and brake cleaner first. Use a straight edge and Sharpie to mark a parallel line with the length of the tube. Use a tubing cutter and cut out enough section to maintain the original length. Point 1/8 NPT in a direction that will be free from obstructions when installed and tighten using the Sharpie lines as a guide. Spray off Sharpie lines with brake cleaner. This post was for entertainment purposes only and not intended to be instructions. I had great success with this product that was inexpensive and surprisingly good quality.
Paul R. Haller
Reviewed in the United States on July 29, 2016
Worked perfectly in my 2008 Dodge Cummins diesel with a 68 RFE tranny. No leaks so far and easy to use. Just buy this if you need to add a temp probe in the tranny line that uses a 1/8 pipe temperature probe.
Recommended Products
$30.99
$ 12 .99 $12.99