Your cart is empty.
Your cart is empty.-Engine not included. You can put a 3/4 pipe line buying at home depot to get the engine gases out of your garage or any other closed places. Threaded 3/4 NPT Exhaust Flange. Gasket 2 Lock washer and 2 nut included. 1/4" thick flange, heavy duty! 3/4" Male Thread Pipe Fitting Single Male Stainless Steel 304 NPT Tig welded. Good for: Mini bikes, go karts, generators... multipurpose. Fit in the following engines: Predator 212cc (6.5hp) Predator Hemi from harbor freight. GX160, GX200. Powerhorse 208cc, DuroMa XP7HPE 7 Hp... and many other clones, please check the measurements of your engine before you buy. center hollow to hollow 1"13 (see photos for details) Finding the Correct Pipe Thread Size National Pipe Threads (NPT) Pipe sizes do refer to physical dimensions, but the plumbing industry standard for the sizes of pipe is not always as straight-forward as measuring the pipe. Measuring the pipe will oftentimes mislead you into choosing the wrong pipe, so do take care. The "pipe thread size" as shown in column 3 of the table below is measured and based on the inside of the pipe. But, to actually determine the size of a pipe, the outside diameter of each pipe or fitting must be measured and compared to the table for size identification. For example, a 3/4" NPT pipe thread has an outside diameter of 1.050 inches. Each thread size has a defined number of threads per inch (TPI). The 3/4" NPT pipe thread has 14 threads per inch. Both the TPI (threads per inch) and OD (outside diameter) of the thread are required for positive identification of thread size because several sizes have the same TPI.
Donald Rattray
Reviewed in the United States on June 4, 2024
I used this to build a tractor exhaust for my Harbor Freight 212cc Predator engine that I have mounted on my Wheel Horse 657 garden tractor. After purchasing this exhaust I just bought some pieces of threaded pipe and fittings from Ace hardware. I thread a few different angled female pipe fittingss and straight male pipe fittings together, then clamped a tractor muffler onto it. Just like that I now have a custom tractor exhaust stack on my predator 212cc engine.
Greg A. Canham
Reviewed in the United States on December 25, 2021
I used this to build a remote mounted exhaust for a WEN generator. It fit perfectly and mounted to 3/4 black iron pipe from a local retailer..
Customer
Reviewed in the United States on December 24, 2018
Very nicely donePerfect fit
Recommended Products
$49.99
$ 21 .99 $21.99
$15.99
$ 6 .99 $6.99