Your cart is empty.
Your cart is empty.This is a Brand New Upgraded Furnace Fan Control Board.
RJK
Reviewed in the United States on March 24, 2024
Heating/cooling combo unit
dave
Reviewed in the United States on May 26, 2023
This was a near exact replacement for my York gas pack. It's just missing that little green led that doesn't do much. The blower fan started right up after switching the boards out. Great stuff.
Brian Connelly
Reviewed in the United States on January 3, 2023
The board fit and works wonderful. A little variation to the original, no plastic clips in the middle to hold it securely or diagnostic light in the right lower corner wre the only 2 differences. Everything else was the same.
Melissa
Reviewed in the United States on November 19, 2022
My problem was the induction blower would start but no voltage to the pressure switch and thus no gas and or flame. This is a direct replacement although the old one has some terminals that are covered or just not there. Check each terminal one at a time they are all marked. I had to get qtip to clean old box to read the connection Work fine now
B. Robinson
Reviewed in the United States on January 11, 2019
Was replacing a much older ST9120C2002 in an old York gas-pack. This new board wired directly up just like the old one. The one main difference I noticed is that the old board has an onboard green LED light for diagnostics but it basically is just there to tell you if the board has an internal fault & this replacement does not, but an LED for such a basic diagnosis is just plain silly in my opinion so it is not missed one little bit. BTW, I am a professional HVAC tech (22 years experience at this point) and I have a very important suggestion for professionals & DIYers alike whom undertake replacing this model board, if the old one has a plastic cover I do not recommend transferring it over to this replacement board because I have found, via working on many of these units, that when the board eventually fails, and the failure is usually the blower relay overheating and burning out the back solder joints, the board gets hot enough in some cases to ignite that plastic cover which can cause an internal fire damaging many other components / wires. The board is just fine without the plastic cover . This board appears to be appropriate for both 120v & 240v units as long as the low (control) voltage is 24v ac.
LThayne
Reviewed in the United States on August 29, 2018
It took a little longer to arrive, but was a good replacement for my burned out board. This was not an exact fit, tjough. The original has a plastic cover, and this board lacks the holes to match the anchor points from the clip.With a quick cut of two tabs on the cover I was in business.
Ashleigh Oney
Reviewed in the United States on December 7, 2018
A+++
M.
Reviewed in the United States on November 26, 2016
The product was easy to install and works perfectly, allowing us to get an ongoing heating issue fixed just in time for the weather to drop. This particular part costs quite a bit more through other retailers, so finding it at this price was a blessing.
Recommended Products
$767.08
$ 99 .00 $99.00
$29.95
$ 15 .99 $15.99
$179.99
$ 78 .99 $78.99