Your cart is empty.
Your cart is empty.
The same fuse and breaker that is on the old board may be used on the new 140-1130. The 140-1130 controller will need the center wire on the wall switch to be a 12VDC (positive trigger) which on some models of controllers such as the 14-1098 are ground trigger.
Package include:
1 x Slide out relay circuit board
1 x Wire Harness Connector
2 x Slow blow fuse
4 x Spacers for the bottom of board
Steve H.
Reviewed in the United States on April 13, 2025
If you have a Fleetwood motorhome with a big electric slide, it might use this as the control board. It is essentially just a couple motor relays with a fuse and a breaker attached, then runs to a switch.The old-style switch was ground-switched. However, they changed to switching the positive line instead. If your not sure which you have, you may need to consult a pro.But replacing this is super simple. Just disconnect the old harness (they provide a new one in case yours melted or got damaged). Take the fuse from the old one and pop into the holder on the board (check it to make sure it is good and isn't actually the problem). Then, disconnect the circuit breaker from the old board and plug into the new board. Plug in the harness to the board. It is really that simple.Do make sure to use the 4 spacer that are provided as standoffs to ensure the board doesn't short to the frame.Took me about 10 minutes to get it swapped and tested. Back in business.The actual brand-name version of this guy is literally an order of magnitude more expensive, so I was more than willing to try an aftermarket part. As long as it lasts a while, I'm WAY happy.
Recommended Products
