Your cart is empty.
Your cart is empty.
Aftermarket Mercruiser Shift Cable Bellow and clamp. Replaces 74639A 2 for Mercruiser Alpha, Bravo, R, M, MR drives.
Description: Shift Cable Bellows Kit for Mercruiser for #1, R, MR, Alpha, Bravo I, II, III .This listing is for (1)SHIFT CABLE BELLOWS ASSEMBLY #74639A2. For use with various 1983-1995/1998/2002/2004/2006-2007/2009 MERCURY RACING/MERCRUISER STERNDRIVE ENGINES. We have included the part number with this listing, so please do your research to insure it will fit your application.
Replaces 74639A2.
Kit includes bellow and stainless steel marine-grade clamp.
Fits: Mercruiser Alpha, Bravo, R,M, MR drives. Used on all #1, #2 units, Alpha, Alpha Gen II and Bravo I, II, III
Years: 1983-95/98/02/04/06-07/09 MERCURY MERCURY MERCRUISER STERNDRIVE I/O engines.
Part Number : 74639A 2 , 74639A2, 74639A or 61-00504
Please Note: Lube small tip to assist in installation over cable assembly. If you tear the item with pliers and do not lube bellow we will not return or replace item.
Manufacturer PN: BT-MERC-S-74639A2
Brand: JSP
Oscar Rosado Gómez
Reviewed in Mexico on June 14, 2023
El precio excelente y el tiempo de entrega fue muy rápido
adel b
Reviewed in the United States on April 21, 2021
You have to stop selling those boots.I installed 2 last 9 month i use the boat just 3 time , this week my Boat sink because the boot get cracked in 3piece.Be aware do not install it in your boat.I think is made from the trash bags
kim milano
Reviewed in the United States on April 6, 2020
Did the job
Matthew R. Bungard
Reviewed in the United States on July 4, 2019
Install was tough..but I think expected for this job.After 1.5seasons..my bellow tore again..feels like it shouldve lasted longer.
zac
Reviewed in the United States on August 14, 2018
INSTALLED ON MY BOAT BEGINNING OF 2017 SEASON, USED ONE TIME. LUCKY I DIDN'T HAVE TIME TO LEAVE IT IN PORT FOR THE SUMMER, IT WOULD HAVE SUNK. LAUNCHED FOR FIRST TIME END OF JULY 2018, BOTH BOOTS POURING WATER IN, FELL RIGHT APART. ALMOST SUNK THE BOAT AS REAR BILGE PUMP BURNED UP FROM ALMOST CONSTANT RUNNING BEFORE ABLE TO GET IT BACK OUT OF THE WATER. JUNK RUBBER.
denise
Reviewed in the United States on October 10, 2018
This is for sure a 2 person job, but it was not as difficult as some of the message boards on line said.I think it is a bunch of boat repair people trying to scare off the DIYer.
Amber Alexi
Reviewed in the United States on September 8, 2017
Good quality product! Would buy again.
Russell Ivanko
Reviewed in the United States on August 29, 2016
Fit as expected.
DONALD STUART
Reviewed in the United States on August 1, 2016
Worked ok took a little longer to install due to the rubber compound.
Recommended Products
$59.01
$ 26 .99 $26.99