Your cart is empty.
Your cart is empty.
MAX BOND THIXOTROPIC A/B Industrial Grade is a high strength epoxy adhesive used in all types of bonding application for wood, metals, plastics, stone, concrete, and other masonry products. Its mixed consistency is designed to be thixotropic or non-sagging that offers flow control for most bonding applications. It is mixed equal parts resin to curing agent and offers up to 60 minutes of working time and can be handled after 4 hours of room temperature cure.
MAX BOND THIXOTROPIC demonstrates excellent adhesion, toughness and water resistance suitable for the marine boat building, aerospace grade adhesive, automotive assembly, and composites bonding application
TYPICAL USE AND APPLICATION
Strong Adhesive For Bonding Wood, Metals, Concrete, Fiberglass
Boat Deck Construction
Fiberglass Boat Hull Construction
Fillet Bonding
Scarfing Adhesive
Vertical Bonding Adhesive
Wood Sealant And Protective Waterproofing
Wood Laminating, Patching, Gap Filling
CONFORMS TO AEROSPACE/MILITARY/NAVAL SPECIFICATIONS
MIL-A-8623 T1
MS-511
MMM-134 Type1 and Type 2
OS-9923A
Boeing BMS-5-29
Complies to NASA Requirements For Low Outgassing Polymers
PHYSICAL AND MECHANICAL PROPERTIES
Mix Ratio: 1:1 By Weight Or By Volume
Mixed Consistency: Gel-Like
Working Time:45 to 60 Minutes
Handle Time: 4 to 6 Hours At 75°F
Full Cure Time: 24 to 48 Hours At 75°F
Hardness: 78 to 80 Shore D
Tee-Peel Strength:4 Lbs. Per Inch Width
Compressive Strength:15,800 psi @ 77°F (25ºC)
Tensile Shear Strength:
3,700 psi @ 77°F (25ºC)
2,200 psi @ -112°F (-80ºC)
1,450 psi @ 212°F (100ºC)
Elongation Maximum Yield: 2.3%
Service Temperature-67°F to 250°F
Jeremy Jones
Reviewed in the United States on June 17, 2024
I used this product to repair vertical filon delamination on camper. Prior to purchase I also contacted customer support for this product with questions and concerns. By far the most friendly and most knowledgeable customer service as well. Will purchase this product again if needed.
gary
Reviewed in the United States on September 6, 2023
Great product
Bradley J. Hardy
Reviewed in the United States on September 6, 2021
This is not what I thought it would be. It works well for some jobs but not all. Its supposed to be thixotrpic but I found it to be pretty runny. I attempted to patch a 1/4 hole in a boat seat. I put tape on the backside and the epoxy still went through. It's very similar to fiber glass epoxy. I was expecting something like PC 7 or PC 11. Not a bad product just not what I thought it would be
Recommended Products
