Your cart is empty.
Your cart is empty.The MEAN WELL 120W single output industrial DIN rail power supply weighs 1.4 lbs and measures at 2.6" x 3.9" x 4.9". the devices input current at full load is 2.8a (115V)/1.7a (230V). setup, Rise time is 70Ms/115VAC at full load. Efficiency is 84 percent. Overload is 105 150 percent rated output power. Overload voltage is 29 33V. Overload temperature is 90 Degrees Celsius. Protection Type: constant current limiting, Recovers automatically after fault condition is removed.
Elston S.
Reviewed in the United States on September 7, 2021
Used a few of them. No problems
David Heaton
Reviewed in the United States on July 2, 2021
had to replace an old power supply with something beefier and this has worked great. fit perfectly and supplies the rated power. i measured the output on my o-scope and its low noise under a variety of loads and can handle load level switching smoothly.
Gokhan
Reviewed in the United States on July 27, 2019
I used it for a bridge saw stone cutting machine. Working good.
Ronald M. Hatcher
Reviewed in the United States on August 19, 2018
Fit the application perfectly, great product!
David R. White
Reviewed in the United States on December 28, 2017
Good power supply, but a little large than I was hoping for.
J. Keller
Reviewed in the United States on January 18, 2017
It works fine.
Vic S.
Reviewed in the United States on January 13, 2017
The reason I bought this power supply for my home experiments is because this is the exact power supply I have in my mega dollar industrial control panels. If it's good enough to reliably last in a 110F degree environment, it's good enough for my home laboratory.
Salty Donkey
Reviewed in the United States on December 20, 2016
Very good value, this has been rock solid for me at 1/3 of the cost of some of the other brands.It's well built and robust enough for what I needed, which is running my CNC lathe's DC controls.
Recommended Products
