Your cart is empty.
Your cart is empty. OEM MTD Part Number 753-0654 Replaces Prior MPN 711-1068
Compatibile With:
ACE: 670F, 673G, 675G
Agway: 670G, 675G, 695G
Hechinger: 675G, 695G
Huskee: 673G, 693G, 693H
Lawn Chief: 673F, 679G, 679H, 699G
Lawn General: 675G, 690G
Lawn Hawk: 670G
Mastercraft: 660G, 673G, 673H
Mastercut: 670G, 675H
Montgomery Ward: 661F, 670G
MTD Gold: 673F, 679G
MTD: 660F, 660G, 661F, 667F, 670G, 675F, 675G, 675H, 677F, 678G, 679H, 690G, 695G, 695H, 765N
Power Kraft: 690G, 699G, 699H
Ranch King: 619G, 675G, 699G, 699H
Select Series: 660G, 665G
Servistar: 660G, 673G, 673H
Statesman: 660F, 678G
Turf Power: 670G, 679H
Turf Pro: 660F, 675G, 679H
White Outdoor: FST-16, LT-125, LT-15, LT-155, LT-16, LT-165
Yard-Machines: 660F, 660G, 665H, 670F, 670G, 675H, 695G
Yard-Man: 694F, 694G, LT-38, LT-42, LT-46
Please Refer to Original Equipment Owners Manual to verify Compatibility
DuginMT
Reviewed in the United States on June 7, 2018
This comes with new ball joint ends which are needed because this link is larger in diameter than the original. The original nuts do fit the ball joint studs, so you will need to save yours. Hardest part was removing and reinstalling the rear ball joint, but I didn't have to take the mower apart, just took some time because there is barely enough room to get and end wrench in. Then, you to adjust the front ball joint out until your mower turns left and right about the same. Happy with this unit, should not break like my old one did after 20 years!
Pete H
Reviewed in the United States on April 20, 2018
Beefier version of the original, works well. Contained drag link lock nuts, but did not come with new nuts for the joint.
A Bull
Reviewed in the United States on September 5, 2010
A little hard to install but is working fine.Seemed a little expensive for a piece of steel but you need it to steer the mower.
Recommended Products
$299.99
$ 99 .00 $99.00