Your cart is empty.
Your cart is empty.Omix offers high-quality replacement parts for your Jeep that meet or exceed OE standards for a great fit and reliable performance. This replacement CV driveshaft repair kit fits 07-18 Wrangler JK / JKU models. Fits front or rear driveshaft. Kit includes CV joint assembly, end caps, gasket, clamps, bolts, snap ring, and grease. Replaces OE 528533FRK
Teresa Twijnstra
Reviewed in Canada on March 27, 2024
It fixt my problem
Alan E Esler
Reviewed in the United States on December 9, 2024
I used this to replace another repair kit that failed over time to protect the joint.
chad g.
Reviewed in Canada on December 4, 2024
this kit was twice the cost of the other cheap ones on amazon and its the same thing, not pleased when i thought i was buying a quality Omix ada part
Jesse H.
Reviewed in the United States on December 20, 2024
Was professional installed rubber boot busted in less than 2 year allowed water in and caused rust which caused drive line vibration!! Never off-road woman driven well maintained!
David Cantago
Reviewed in the United States on June 16, 2022
Ive installed a few cv joints before. I usually buy the rzeppa kit from terraflex but I decided to pay a little less for this one.I installed the bearing joint properly with the correct side facing out. Installed the snap ring and made sure it was seated correctly. Packed all the grease that was supplied. Torqued all bolts to 15ft lbs.I was on the freeway and the joint gave out spitting out my drive shaft.Don’t buy this.
asc
Reviewed in Canada on April 13, 2022
part exactly as described , much cheaper than replacing driveshaft
Rich
Reviewed in the United States on December 31, 2021
Fits perfect! Back on the road thank you!
Mindy Harding
Reviewed in the United States on November 8, 2020
Easy to install, exact replacement for my 2010 jeep wrangler unlimited.
Christopher
Reviewed in Canada on November 23, 2020
Good replacemement part. Pricey, but the cheaper knock offs are junk. Easy to install.
Customer
Reviewed in the United States on December 9, 2019
Was very easy to install
Eric
Reviewed in Canada on December 18, 2019
The Jeep is running good s new!
Customer
Reviewed in the United States on May 16, 2018
Everything came included except the clamp. Not a big deal because I had one, but just so other buyers know. Actually purchased another one because a lifted jeep can always use a spare.
P.K.
Reviewed in the United States on September 30, 2017
Factory driveshaft CV joint on my JK gave up the ghost at 61000 miles. Upgrading to the fancy heavy duty aftermarket driveshaft wasn't in my plans, so I decided to try this kit.Installation is easy for anyone with basic mechanic skills (all you need is 8mm socket, mallet and screwdriver), just a little messy (you have to pack the bearing with included grease), so make sure you have some paper towels available. There is no instructions included with the kit, but there are some good videos on YouTube (check the one from Teraflex).I gave it 4 stars instead of five because picture shows a tube of silicone gasket maker included, although in reality it didn't come with the kit. Wasn't a big deal for me (I already had a tube of Permatex in my toolbox), but other folks may need to get it separately.Now I have ~1500 miles on this new CV joint, it is a bit too early to tell, but so far it holds up well with no signs of wear or grease spill, hope it'll survive for a few tens of thousands miles.
Recommended Products