Your cart is empty.
Your cart is empty.Easily removes damper pulleys. Fits into tight engine compartments, no need to remove radiator. Specially designed jaw tips fit small puller pockets found on the back of the Pulley.
Spridle
Reviewed in the United States on May 29, 2018
I used this extra leg with my "OTC 6574 Universal Heavy Duty Hub Puller". Its a perfect fit. I needed the extra leg to get even pressure to pull front hubs on a 2005 GMC Canyon 4x4. I bolted the legs directly to the studs.
Dave
Reviewed in the United States on November 15, 2018
Well built H.D. leg for OTC 7394 puller. Drop forged and heat treated. Rated to 20 tons. Hub and axle spline seizure appears to be a common problem, due to the fact the Mfgr's eliminated the dirt seal and water sling that used to be at the end of axle joint to protect the union of these two parts, they also make no effort to use anti seize, hi temp grease or anything to prevent this from ruining your day. Use of the puller can damage the bearings for the hub and maybe the hub itself, so keep this in mind as the hub and bearing(s) may have to be replaced. The idea is to save the axle at min as the costs start to add up
Clay Raedeker
Reviewed in the United States on April 15, 2016
This was a 100% positive experience. Absolutely no complaints.
JACK SCHILLING
Reviewed in the United States on April 20, 2015
worked great
Floyd Dianetti
Reviewed in the United States on April 10, 2015
This puller is built very well and works great, they should sell extra leg with puller and adjust price accordingly. Don't make the leg an extra to buy later.
kickent
Reviewed in the United States on August 15, 2014
I wish the actual dimensions of the puller leg had been posted because modifications will be needed to allow it to work with my other puller legs as a unit. Still much better than trying to make the leg from scratch!!
Phillip R Popp
Reviewed in the United States on October 10, 2014
A perfect match for the legs that come with the OTC 7394 Hub puller. Same high quality.
klepac
Reviewed in the United States on March 27, 2011
This puller is well made of thick hardened steel and is large enough for any job. I was able to remove a 16in wheel hub that had been rusted on for 50years. The unit didnt even get a scratch.
Recommended Products
