Your cart is empty.
Your cart is empty.Upgrade your junk OEM hub bolts with these 10.9 Class (metric equivalent to Grade 8) hardened yellow zinc plated hex flange bolts. These bolt the front wheel hubs / bearings to the steering knuckles. These fit better than the tapered factory bolts which were designed to reduce cost. They have far better corrosion protection over black oxide and have a larger hex head which is less likely to cause you problems the next time you need to remove them. Includes 6 bolts, enough for both the driver and passenger side. Fits: Wrangler JK and Unlimited JKU 2007-2018, Grand Cherokee WJ 1999-2004. Replacement for Mopar 5012436AB
Thomas P.
Reviewed in the United States on March 22, 2025
Prefect fit for my 2002 Jeep Grand Cherokee WJ. Replaced those stupid 12-point bolts on the knuckle.
hunter
Reviewed in the United States on January 7, 2025
Fit like the originals
Amy E Tooley
Reviewed in the United States on April 13, 2025
If you drive a Jeep JKU and wheel it often. Buy these. You’ll thank me later…oh and they are great quality. I’ve had to take my front end apart no less than 10 times since first installing.
Alek
Reviewed in the United States on September 26, 2024
Perfectly replacement for the stock unit bearing bolts. No issues installed on a JKU.
Charles Merritt
Reviewed in the United States on August 14, 2024
When the OEM ones strip the heads (when not if) and you finally get them out replace them with these. Larger socket size is just as accessible as the small head 12 pt bolts from the factory. A good upgrade if you live where it does not rust, a must have upgrade if you live anywhere they coat the roads with salt.
Jay
Reviewed in the United States on December 3, 2024
The head of these bolts are too large and come in contact with the axle on rotation. Tried to use on 2015 jk
Recommended Products