Your cart is empty.
Your cart is empty.This filter is designed to be installed in the upper radiator hose. Installation of the "Full Flow" filter will stop radiator and heater core clogging due to rubber from hoses, foreign particles and rust scale. Filter is transparent and can easily be cleaned.
Sean Cantrell
Reviewed in the United States on December 1, 2024
Product cracked into pieces.Was installed on Classic Car that was hardly driven.
Jerry
Reviewed in the United States on July 23, 2019
This is a must have for any classic car with a cast iron block!!! I am restoring a 72 Gran Torino that has been sitting in a garage for 12 years. I knew that the block and the water pump were filled with rust so I replaced the water pump, thermostat, thermostat housing, and heater core fitting because they were all rusted out. After flushing the block with all of those parts off put all new parts on. As a safeguard to trap remaining rust and help the radiator not get clogged I put this gano filter in and it works great! It has already trapped a bunch of rust. It is very well built and as long as you don’t Hulk tighten the clamps it won’t crack. The only thing I wish they did better is the cheesy metal wire that you have to use to tie the clamps together. Look at the pictures and see all the rust particles this has already trapped!
lordmattbob
Reviewed in the United States on October 11, 2018
I wasn't sure about getting this, but as soon as I could see my vehicle burping and see when the thermostat was opening (microbubbles flowing through) I knew it had simplified my radiator install. Now with a new thermostat housing installed with temp prob I can tell when the thermostat opens both from the cab and the engine bay. I'd buy again.
Dan Hyduke
Reviewed in the United States on September 26, 2017
catches larger chunks that could plug a tube, but doesn't filter fine particles. also difficult to clean
AjL227
Reviewed in the United States on September 12, 2017
Cracked during initial radiator hose fitment.And it would have only cracked eventually leaving me in trouble.Frail, fragile and overpriced.
Robert
Reviewed in the United States on August 28, 2015
I purchase this product online in July and did not get around to install it until this august. in the installation process I noticed that the outside housing had hairline cracks. The direction state to tighten by hand which I did but still notice the cracks and since this was going to be install inline with the radiator house and exposed to heat , i did not want to take a chance on it failing while driving. looking for warranty information from vendor as I waited to long to install for amazon warranty. Will follow up once I get a response from vendor or amazon.
T. Culbertson
Reviewed in the United States on March 28, 2015
Great product. I installed one on my '65 Mustang and it works great. It gets 4-stars only because it is difficult to clean (stuff can get stuck between the layers of mesh). I would definitely buy this again or recommend it to a friend.
Michael
Reviewed in the United States on November 23, 2015
Cracked after a month of use... left me stranded and over heated my motor.
Recommended Products
