Your cart is empty.
Your cart is empty.Brianne
Reviewed in the United States on September 26, 2023
Very nice
Nat730
Reviewed in the United States on June 27, 2020
Does not fit the micro mini scooters as a replacement - I ended up just getting it from the manufacturer. I’m sure these would work well for most inline skates
Bradley Nunes
Reviewed in Canada on June 22, 2020
These were exactly what I needed to fix my kid's inline skates.
Mike Hall
Reviewed in Canada on June 14, 2020
Needed, ordered, received, swichted out old put in new ....easy breazy lemon squeezey
Teddi Agues
Reviewed in the United States on February 11, 2020
Worked on grandsons skates.
David
Reviewed in Canada on October 29, 2020
The tip of the Hex Shaft mushroomed after a few weeks of use, luckily I only used it for the brake wheel I removed. But getting these bolts out of the frame of the rollerblades was near impossible.
cbarton68
Reviewed in the United States on April 29, 2020
Bad product. They were the wrong size and on my first ride with them, the screw broke out of the shaft causing me to lose my front wheel and fall. Pulled a hamstring that took about a week to walk right again. Garbage product. Too thin and long. Spend the extra money and get some decent ones.
Rozexfeen
Reviewed in Canada on August 25, 2019
Mes patins roulent, mais pas plus.
Carlene
Reviewed in the United States on July 26, 2019
This was a excellent quality product and good value for the price, however the size was too long for my needs. It did not work with my rollerblades, and I did have to return the product. The return was made without any hassle, and I’m satisfied.
Alex M
Reviewed in the United States on February 8, 2019
Decent price. Seems well made and with a dot of blue threadlocker. I needed to gently file the threaded end to reduce the length of the axles to match the width of the skate truck frame to avoid "riveting" the axle into frame. Amount filed was less than millimeter but it was a lesson learned from a previous experience when the overly long axles flared with tightening and had to be drilled out to do a wheel change.
Graham OBray
Reviewed in Canada on April 22, 2019
Came as expected
Alonso
Reviewed in the United States on June 17, 2018
The screws were fine, the width fit perfectly, but, because I was naive to think there was only one size, the length was 5mm too large. Make sure to measure before buying.
Anonymous
Reviewed in the United States on October 5, 2017
Nothing wrong with the item but it is smaller than regular roller blade bearing diameter. My own fault. Length is a tad shorter, for me it was the Zetra Blade ~$100 that I was looking to replace a shaft on.I lost a wheel and so I needed replacement shaft(s) for it. Mostly though and somewhat thankfully I needed the male nut if you can call it that. And it does fit my original shaft.Edit: actually I'm wrong again, this particular shaft is a slightly longer one (the original) it's for the back break which goes around the "wheel holders" so it's slightly longer. The lengths match but diameters don't.
Recommended Products
