Your cart is empty.
Your cart is empty.This is a Brand New Upgraded Aftermarket Furnace Control Board. The control board is the brain of the furnace.
luis
Reviewed in the United States on January 27, 2024
At first I was worried because it looked so different from the original. Then I realized it was an UPGRADED circuit board. Easy to install. Furnace fired right up.
Customer
Reviewed in the United States on March 3, 2022
This control board has been working flawlessly. Do not hesitate, Buy it if you need it.
glvdj
Reviewed in the United States on March 30, 2019
Works great. The plus side, the original did not have the diagnostic LED, which makes this one better.
Adam Fischer
Reviewed in the United States on December 29, 2018
Worked like a charm!
logan
Reviewed in the United States on January 25, 2017
easy installation and does the job.
pokerpilot
Reviewed in the United States on January 14, 2017
It has worked flawlessly since installation. Just as good as the one Carrier uses and at a significantly lower price.
Customer
Reviewed in the United States on November 14, 2016
The panel worked perfectly. My furnace is working great now.
K-Man129
Reviewed in the United States on January 19, 2015
The ICM281 was a good replacement for my Carrier's original CESO110057-02. It performed well after installation-dare I say "better" as it keeps the house temperature within a degree of the setting (the original board would allow a ± 3-degree swing before kicking in/shutting off.You should know that the ICM281 is available from other sources for as much as $50 less. However, shipping was free and relatively fast (USPS Priority), and by installing it yourself, you're still saving quite a bit over hiring a "pro" who would mark it up even further.Only complaint: the directions for the "self-test" printed on the inside of the box did not quite match those printed on the self-adhesive label included with the product. My findings:Use the label directions. Connect all wires, including "W", "Y", "C" and "G" thermostat wires; DO NOT connect the "R" (red) wire. Then, briefly (1 second) short the "C" (cyan + 24V-Common) terminal to the "TEST/TWIN" to start the self-test. After the test, reconnect the "R" wire.Another easy (but important) step when servicing your furnace: Clean the Flame-Sensor Rod using fine sandpaper (search youtube videos for demo). Be sure to wipe off any sandpaper residue with a clean cloth before re-attaching it (one screw). The new board will react much more accurately if you clean off the steel wire. This 5-minute step is very important if your furnace is > 8 yrs. old and/or does not have a separate vent pipe to draw in outside air for the burners.Five-stars for the product, 3 for price and testing directions: thus 4-stars overall.
Recommended Products
$174.95
$ 74 .99 $74.99