Your cart is empty.
Your cart is empty.Westin(TM) E-Series Bull Bars are a front-end light bar designed for trucks and larger model SUVs. It is made of 3 diameter polished stainless steel tube. It mounts utilizing existing vehicle mounting points and installation does not require any drilling to the vehicle frame. Comes complete with mounting kit the Westin(TM) E-Series Bull Bar provides a mounting point for 2 auxiliary lights up to 6 in diameter. It features a die-cut Westin(TM) block logo design on the stainless steel skid plate unique to the Westin(TM) E-Series Bull Bar.
Customer
Reviewed in the United States on December 29, 2016
Bracket holes do not line up for 2015 Tacoma. Hole placement is correct and if they'd make one hole adjust about half inch more it'd be perfect. Sucks to pay so much for something and then have to modify it.
Chad Delnista
Reviewed in the United States on May 27, 2015
Put on 2015 double cab Tacoma TRD Off Road. End result is that it looks great. Only problem was the right side bracket did not fit properly and required modification to the bracket to make it fit. If it weren't for the pain and struggle of having to modify that bracket, it would be 5 stars hands down.
T. Pratt
Reviewed in the United States on July 21, 2014
Perfect fit 2014 Tacoma with a ~60 minute install, and that was mainly because of the contortions you have to go through to reach the Toyota bumper mounts which the product uses as part of its fixation to the vehicle. The product is well made, and surprisingly light. Unlike the photo on Amazon, it does have a "Westin" logo cut into the front of it in the skid plate area. The supplied bolts are 8.8 grade - these equate to grade 5 in the scale most of us are familiar with, which should be more than adequate for the purpose. Irritatingly, they are 16mm, which most socket sets don't have - happily, 5/8 is a near perfect fit. FYI, the bumper mount nuts you have to undo and then re-use are 14mm, so be prepared. On the 2014 Tacoma, the front license plate is still visible after install. Pacakaging was good and instructions clear. Recommended.
Retired Senior Chief Petty Officer
Reviewed in the United States on March 22, 2014
Pros: Good build quality, nice barCons: Not the easiest thing to install because two of the mounting bolt locations are in a very tight spot. Not the fault of Westin. They used what they had to work with.Advice: Go slow, open your hood to see what is the better angle.
Winnie
Reviewed in the United States on March 21, 2014
This is a very nice product. It looks good on my truck. It was fairly easy to install with a slight modification to truck's bumper bracket weld.
Brian McCarver
Reviewed in the United States on April 7, 2014
Item was delivered with a small dent on the front top of the bar. Was pleased with everything but that. It's a little to much money to pay for damaged product.
David L. Reid
Reviewed in the United States on April 1, 2014
Takes a lot of contortions to get installed but I did it by myself in the drive way.Expensive for sure but I believe it is going to last.
VA Reviewer
Reviewed in the United States on February 15, 2013
Looks nice on the 2007 Tacoma, except from the side where it's obvious that the support bracket is not proportional nor as beefy as the main tube. Not quite as easy to install as some would have you believe but can be done in an afternoon. A second person is needed for about ten minutes. I also got to discover what I'm sure every real mechanic knows; that a 16mm wrench is almost exactly equivalent to a 5/8" wrench.
Recommended Products
$263.25
$ 99 .00 $99.00
$910.92
$ 99 .00 $99.00