Your cart is empty.
Your cart is empty.It comes with 4 thick stiffness washers, Ensure that they can be used smoothly. Tighten the nut before use so that the washers are in a fixed position, the warping of the washers will lose the ability to hold the pads in place. Before securing the Skids in place, make sure the bottom surface is parallel to the ground so the Skid wheels are the only point firmly on the ground. Check the Skids and adjust as needed after each use IF you happened to bump/run over cracked/uneven sections of sidewalk as that may bump the Skid out of adjustment. As you use your snow blower, make sure to lift the Skids off the ground (press down on the your snowblower handles) before making any turns, otherwise, by sliding sideways on those Skid wheel will likely cause flat spots and lead the wheels to become inoperable.
dave
Reviewed in the United States on March 28, 2025
Super slick and rugged construction. Much better than the metal ones.
Jack
Reviewed in the United States on February 25, 2025
machine is much easier to move around
HK
Reviewed in the United States on December 9, 2024
Updated experienceFirst experience - Worked good for maybe 20 minutes then wheels blew apart and pieces disappeared.Great idea, reduced effort to move/push snowblower (It is a big Toro) in the garage.Hoped for the best but was suspicious that plastic wheels would hold up under the weight AND because of the amount of "play" of the wheels on the small shaft. Without hard, durable wheels on a shaft without play AND without support of bearings they are going to destruct.------------------------------------------------------------------------------------------------------------After the initial use and failure. I found the wheels while shoveling after another snowfall.They did not destruct.Even though I fastened the bolt/axle with a rachet to assure they were secure, They un-bolted themselves because I have to do a lot of backing up with the snowblower. I can only assume the weight on the shaft while in reverse was enough to completely un-bolt the shafts.I'm going to clean the shafts thoroughly, add Loctite and bolt them as tight as possible.Will update.
pat schuster
Reviewed in the United States on November 16, 2024
Arrived on time and fit well. We have not had snow yet but appears that it will work well. comes with a spare pair of rollers
bar b q God
Reviewed in the United States on January 19, 2024
Like the fact on my gravel driveway I don’t throw rocks all over the place works great
Anthony Blank
Reviewed in the United States on February 23, 2022
Broke within 3 uses on my driveway.
JEFF
Reviewed in the United States on February 23, 2022
Worked fine the first snowblow. Second go round, a small pebble got stuck behind the wheel, which in turn apparently never turned after that. Almost worn down to nuttin.
Patrick Cambria
Reviewed in the United States on January 30, 2022
First fail was probably less common but 1 of the stainless steel nuts gallery on the stainless bolt and as a result stripped out the square hole in my snow bower...Once I cut it off with a hacksaw and put the factory fasteners on I started snow blowing. Two minutes later I realized the wheels snapped right off....Avoid this product like the plague.!
Recommended Products
$29.99
$ 13 .99 $13.99