Your cart is empty.
Your cart is empty.Product Description
- This marine motor propellers with fine workmanship, having the characteristics of high strength, resistance to sea water and river water corrosion, featuring very durable and practical. This electric thruster blade propeller is simple operation, easy to maintain and repair. Easy to replace old or damage propeller.
- Product Size: Approx. 21.5*21.5*4cm/8.5*8.5*1.6in
- Aperture: Approx. 9.9mm/0.4in
- Three-blade propeller fits for 28/36/46 pound propellers
This plastic thicken propeller is extremely durable without affecting maximum speed, acceleration or rmps, reducing engine wear and fuel efficiency. Ideal to replace for the old.
This outboard motor propeller is designed for improve speed and efficiency. Designed and built to deliver outstanding weedless shallow-water performance.
3-blades designed for speed and efficiency with weed less, power, and shallow water options . This boat blade electric propeller is wonderful accessory for electric thruster.
Carrie
Reviewed in the United States on April 8, 2025
Super great product and the quality was unbelievable perfect would for sure buy again anytime
Customer
Reviewed in Canada on April 20, 2025
It doesn't fit as tight as the original propeller, the shaft is about 9.46mm, the propeller hole is 9.96mm. There is a bit of play. I wrapped the shaft with one layer of metal tape (Home Depot, used for air ducts), and now it fits tight. I had to file a little burr on the propeller that ripped the tape as I pushed it on the shaft. I don't know yet if it's better than the two blade propeller, still to find out.
Private
Reviewed in Canada on September 11, 2024
May not be 'weedless' but I run it in grass and lillies. So very smooth because of the three blades. Buy 2. Using it on a minn kota 40lb.
DanBorn
Reviewed in Canada on July 1, 2024
way better than my other 2 finned prop more thrust as well over all a 5 star purchase
Trent k.
Reviewed in Canada on June 25, 2024
Solid unit, upgraded from my 2 prop on my 89 Kota would deff buy again!
Brian S.
Reviewed in the United States on December 7, 2024
too small for motorguide trolling motors.
S Graham
Reviewed in the United States on November 17, 2023
This prop seems to be built as well as factory.Description says up to 46# thrust...It fit the shaft and pin of my 40# Motorguide, but the outer barrel diameter of this prop is 3 1/5" and my Motorguide is 3 1/2". The total blade diameter is the same, but the cross section of each blade is about a half inch narrower. Did not install, so no test review. Returning due to fitment.
Erik Aguayo Hernandez
Reviewed in Canada on November 17, 2023
The media could not be loaded.
Recommended Products
$30.90
$ 15 .99 $15.99