Your cart is empty.
Your cart is empty.Engine Crankshaft Position Sensors measure crankshaft location to detect misfire and control engine timing. If you have a engine check light P0335 and your car isnt running right, it may be time to replace your faulty Crankshaft Position Sensor. Fit 04-06 Buick Rainier/04-05 Cadillac Cts /02-06 Cadillac Escalade /02-06 Chevrolet Avalanche 1500 /98-02 Chevrolet Camaro /97-05 Chevrolet CorveTTe /03-07 Chevrolet Express 1500 /03-07 Chevrolet Express 2500 /03-07 Chevrolet Express 3500/2006 Chevrolet Impala /2006 Chevrolet Monte Carlo/99-06 Chevrolet Silverado 1500 /2007 Chevrolet Silverado 1500 Classic /99-09 Chevrolet Silverado 2500/2007 Chevrolet Silverado 2500 Classic /01-06 Chevrolet Silverado 3500 /2007 Chevrolet Silverado 3500 Classic/03-06 Chevrolet Sonora /03-06 Chevrolet Ssr /00-06 Chevrolet Suburban 1500 /00-06 Chevrolet Suburban 2500 /00-06 Chevrolet Tahoe /2006 Chevrolet Trailblazer/05-06 GMC Envoy /03-07 GMC Savana 1500 /03-07 GMC Savana 2500 /03-07 GMC Savana 3500/99-06 GMC Sierra 1500 /2007 GMC Sierra 1500 Classic /99-06 GMC Sierra 2500/2007 GMC Sierra 2500 Classic/01-06 GMC Sierra 3500 /2007 GMC Sierra 3500 Classic /00-06 GMC Yukon/00-06 GMC Yukon Xl 1500/00-06 GMC Yukon Xl 2500/03-07 Hummer H2/98-02 Pontiac Firebird/05-06 Pontiac Grand PriX/04-06 Pontiac Gto/05-07 Saab 9-7X4.8L, 5.3L, 5.7L, 6.0L V8
Paul s.
Reviewed in Canada on March 10, 2025
Doesn't work! had to put the old one back in, in order to pick one up locally. No quality control by manufacturer.
Diane
Reviewed in the United States on April 22, 2025
Did not work at all!!!! Wound up putting the old one back in until I could order another
Krista Lee Haas
Reviewed in Canada on May 8, 2024
Installed fine but engine still wont crank showing same codes
john g.
Reviewed in the United States on December 4, 2024
After replacing the sensor engine still had no ability to run pulled the accessory drive and front cover to check the timing marks (which were dot to dot )on a new Ls I build after hours of troubleshooting replaced the new sensor with a new USA manufacturer started right up the lesson is sometimes a cheap part is a cheap part
Customer
Reviewed in the United States on September 27, 2023
The crank sensor is made wrong. The hole for the retaining bolt didn't line up.
Terry Noland
Reviewed in Canada on July 19, 2023
Part was suppose to fit 2002 Chevy hole in bracket didn't line up with hole in motor
macmbc
Reviewed in the United States on October 14, 2023
2002 GMC Yukon xl 5.3 - The metal tab on this part is about 1/16 longer than the OEM part which means the hole for the bolt is also off by that much. I had to expand the hole in the tab in order to get the bolt in. They should've done a better job of making it the exact same size.On top of that, the part is defective. After installation, truck wouldn't start. Replaced with old part and it started right up.
Chris Gregory
Reviewed in the United States on January 3, 2023
While rhe advertising says it will fit a 2001 6.0 Chevy engine, it absolutely will NOT. As you can see in the pictures, the mounting hole is not anywhere near the same as OEM and will Not bolt to the engine because of it. Also, the plastic shaft is ever so slightly bigger than the OEM sensor when you get it 90% in and will Not go 100% into the engine. And even with it only sticking out just 2 or 3 millimeters, the engine would not even start. The O-Ring seal portion of the sensor will go in, but the last few millimeters of the sensor is too thick and will not go into the block. I ended up putting the o-ring of the new sensor onto the old sensor and that worked just fine to stop the oil leak. Also, the old sensor went 100% back into the hole.If you're just trying to stop an oil leak on your engine, just replace the o-ring on your current sensor and you'll be fine.
john smith
Reviewed in Canada on September 3, 2022
The part don't work the anchor point hole is off the part was faulty once installed it was rubbing in side and truck never started I went to auto part store bought one installed and the truck started no more codes.. buyer beware
Guy Q.
Reviewed in Canada on December 15, 2022
Cette pieces ne convient pas a un GMC Sierra 1500 5.3 l 2001
gabriel rivera
Reviewed in the United States on November 27, 2022
The bolt slot was off and it was slightly thicker.
Recommended Products
