Shopping Cart

Your cart is empty.

Your cart is empty.

Edge Bander Woodworking Edge Banding Machine,110V Portable Edge Bander 2000W,Curve Straight Edge Banding Machine for Board Edging

4.3 (1) Write Review
Free shipping on orders over $29.99

$299.00

$ 99 .00 $99.00

In Stock
  • 【Woodworking Edge Banding Machine】 110V voltage, 2000W maximum output power, can efficiently heat the edging strips to achieve the edging effect, protect the board, reduce the wear and tear and cuts caused by external factors.
  • 【Important parameters】 Max banding width 50mm , with thickness of 1mm。Max banding width 30mm , with thickness of 2mm 。The narrowest banding width: 5mm.Suitable for straight line or arc edging work, can accurately complete the edging work of boards with different bandwidth.
  • 【Portable】 With a net weight of 6.6 lbs, it is small in size and light in weight, easy to operate. It is also portable and can be carried to various scenes for edging work at any time. It comes with an edge trimmer for sealing, polishing and edging wood surfaces.
  • 【Temperature control】 Temperature bound: 50-610℃。Temperature for banding:330-540℃.The temperature can be controlled automatically according to the required dissolving temperature of the sealing tape and hot solvent.
  • 【Widely used】 Suitable for edge banding of different materials, such as melamine paper, wood veneer, PVC, ABS, etc.


Product Description

1
2
1

Hiroshi Tomita
Reviewed in the United States on May 9, 2025
Doesn’t fit 250’ roll of wood edge banding. Unable to keep edge banding lined up with the work piece. On the latter point, I could be using it wrong despite my best attempts to follow the instructions.EDITProduct is working well. Set the grey moving jaws so they are just a hair wider than the edge banding. The black spring loaded clamps will be set to the widest possible setting and seem impossible to fit over 3/4" plywood but it will wiggle on. I have been clamping the plywood to the table laid flat, turning on the heat gun, wiggling the black pads over the pIywood but not yet fully pressed onto the plywood, feeding the edge banding in, then pressing the weighted roller and edge banding to the plywood and rolling it on. Sometimes you need to hold the strip so it doesn't slip. I am using pre-finished maple edge banding and setting it to between 400 and 470 on the dial and that is a good heat for minimal warm up time and rolling it on at a decent pace.ConsStill doesn't hold 250' rolls of edge banding. Measure out and cut strips from the roll until it fits. Manually feed the strips into the heat gun.The weighted roller is not centered properly and rubs the side of the housing which makes the heat gun catch and "jump" when rolling on edge banding.