Your cart is empty.
Your cart is empty.Product Description
It is a fingerprint recognition control panel.It can input 10 administrator fingerprints and 90 ordinary user fingerprints,and can freely choose the relay output working mode (jog/self-locking,delay).It is suitable for access control,car control and more.
1.Input Voltage:DC 7V-30V
2.Output Mode:relay
3.Output Current:10A
4.Standby Current:30mA
5.Fingerprint Collection:100 pieces (MAX)
6.Input Method:fingerprint/manual
7.Output Mode:jog/self-locking/delay
8.Fingerprint Head Size:opening diameter 19mm
9.Work Temperature:-20℃~50℃
10.Work Humidity:5%~95%RH
11.Note: The relay is a contact output,a switch signal,and no voltage output.The relay output contact can be regarded as a mechanical switch.This switch can be connected to an external 5V voltage or an external AC220V voltage.
1.It supports 100 fingerprint storage.
2.It has strong anti-interference ability and more stable performance.
3.It has an LED indicator,which can be used to understand the working status of the product by observing the indicator.
4.It has fast identification and high security,and is widely used in smart door locks,drawer locks,identification,embedded touch and other fields.
Mgregory47
Reviewed in the United States on September 12, 2024
I’m on my second unit after the first one exhibited unpredictable operation. Both seem to work a couple of days and then cease to operate associated electric door lock even though the green light indicates it should be working correctly.Update:About once each week I have to cycle the power to reset it to working state. Everything appears normal but stops decoding fingerprints? DONT BUY. UNRELIABLE
Jim S.
Reviewed in the United States on September 22, 2023
No instructions included. It's not too difficult to figure out.You long press the "set" button to put in fingerprints. All of the feedback occurs through the fingerprint sensor led which changes various colors. I don't recall what is what but its mostly intuitive.You long press the "mode" button to switch modes, which cycles through leds on the board that indicate which mode it's in. Those markings are in Chinese unfortunately, but there's only three so you can just cycle through and figure it out. Mode 1 is scan fingerprint on the sensor and you hold your finger on the sensor. The relay stays open until you remove your finger. Mode 2 is fingerprint scan once to fire the relay, and then fingerprint scan again to close the relay. Mode 3 is scan your finger and the relay fires and then closes itself after a few seconds. You cannot set the length of the delay.I take a star off for no instructions, 1 star off for no adjustable delay, and then finally, a 1 star for the fingerprint sensor always being lit up at all times, which is not documented anywhere. I am using mine for an inconspicuous security feature and I'd like for it not to be lit up or at least to be lit up only when scanning.This one is not a good fit for me and i'm returning it.
Recommended Products
$695.00
$ 99 .00 $99.00