Your cart is empty.
Your cart is empty.This IRWIN HANSON Tap Wrench uses a straight-handle design to provide greater leverage, especially when using larger-diameter taps. This tap wrench is designed for use with taps, reamers, screw extractors and other tools with a square shank.
Josh
Reviewed in Canada on March 12, 2025
Great for smaller taps smallest I've put in is a m3 tap and it fit perfectly for standard 1/4, 3/8 and 1/2 taps it also does the trick nicely
Customer
Reviewed in Canada on August 13, 2024
great replacement handle for my kit, so far up to standards, would buy again
Bob Del
Reviewed in the United States on May 24, 2024
Does what a tap wrench should do. Holds tight even after repeated uses and only hand tight pressure. Much better than the cheap wrenches that came with my original set.
Hyper Speed Media
Reviewed in the United States on March 20, 2024
The size is misleading it’s not for the shaft is actually the tap size. Keep that in mind when you’re buying it. in term of quality it seem to be pretty good and it does the job for smaller tap bits.The handle made out of metal. The top bit secure perfectly into the slots and having to handle, makes it very easy to turn and tap the holes.The quality seem to be pretty good and it should last a long time, but I shall test it more and give an updates later on this product.
Kevin Finnegan
Reviewed in the United States on March 10, 2024
Works like it should. Good quality tap wrench
cruciantime
Reviewed in the United States on December 23, 2024
Great tool
Niam
Reviewed in the United States on December 21, 2024
Works well for smaller taps
Cheng-Tao Chen
Reviewed in the United States on December 15, 2024
Get job done and fit what I need to do.
Ben Cheney
Reviewed in the United States on April 25, 2024
If it's a bigger tap, get this and forget the smaller tap handles. This is a great tool for the money, used for M12-1.75 in 1/2" mild steel.
Racer24
Reviewed in Canada on July 29, 2023
after suffering with cheap tap handles in the past, I am very happy with this unit, it's a good solid real steel tool, good solid grip on all taps from 4-40 to 1/2 NF taps, no slipping or backing off.
Benjamin Millard
Reviewed in Canada on January 21, 2023
Grabs a tap like a Starrett tap handle, holds the tap tight
Richard A. Nardi
Reviewed in the United States on June 11, 2022
I was cutting a 5/16-18 thread into 1/4" steel with my collet type T handle and it would slip no matter how hard I tightened it down. I ended up using a crescent wrench to finish the job. This had no such problem. It is hard to evenly torque the tap down with a crescent wrench. This T handle does it just fine. I did back the tap out a few times to clear the shavings. I also used cutting oil for whatever good that does.
Pierre
Reviewed in Canada on June 29, 2018
Très bien merci construction d'une seule pièce solide, abordables va faire la job
Recommended Products
$24.43
$ 11 .99 $11.99