Your cart is empty.
Your cart is empty.Doug
Reviewed in the United States on April 5, 2025
Very nice rack. Bolted right up. Came with a nice cargo net that was not advertised.
todd sell
Reviewed in the United States on May 24, 2024
This rack is well made and worth the money. Once rack is installed finger tight ... Get it where you want it then tighten all bolts little by little till torque speck is reached. You can remove the seat WITHOUT removing the rack on my 2024 DRZ400s This item looks like it will give me years of service!!
Andrew M BArtholomew
Reviewed in the United States on November 5, 2024
Perfect fit - solid as a rock! Seller was awesome.
Austin Davis
Reviewed in the United States on June 18, 2023
Great rack, fits fine using the stock hardware, albeit I got longer M6 [10mm head] bolts as they hold the tusk pannier mounting rack as well. Super happy to find a simple, straightforward looking rack. I hate the crazy looking "plate" racks that have holes cut through all of them. This one looks nice on the DRZ.
Customer
Reviewed in the United States on September 23, 2022
It was easy to install. It came with new screws. It looks good on my black DRZ400S. It is slightly crooked if viewed from the back but only I notice it. I would recommend! Buy a set of Roc Straps to go with it. You’ll thank me.
mike
Reviewed in the United States on February 24, 2020
Very sturdy, size and shape very good fits the fender line very well. Install was easy, however where it mounts to the seat bolt was a little wide. Instead of bending the rack to fit, i just installed the provided bolts and slowly and equally tightened them up, work great and looks great too. Oh yes very solid and sturdy mount and rack, Very happy.
KP
Reviewed in the United States on April 24, 2020
It's a good rack for the money. I put my trail tool bag on it. It came with a cargo net that wasn't of any use to me. I just have a bag that clamps to the tubes. My drz400 is setup for dirt only, so it handles all the bumps and rough terrain just fine. My tool bag weighs about 7 lbs, closer to 10lbs with spare tubes and the tire inflator. I don't know the weight capacity, but it's probably good for about 10-20 lbs would be my guess.As far as the install goes, I had to drill the 2 rear holes as it didn't line up with my existing holes. I'm not sure if my bike has non-stock plastics or if the rack is off a bit. I bought the bike used and it had some aftermarket stuff on it already. No big deal, I put the existing screws back in and drilled new holes. Only took 10-15 minutes to install in my garage.
Tall Dan
Reviewed in the United States on January 16, 2016
I have recently installed one of these on each of my two 2015 DR-Z400S motorcycles. I can't comment on the durability because I've only ridden with the rack a couple of times, but so far it has exceeded my expectations. It is very well built using tubing everywhere even in the cross braces and the mounts.I especially like that it was easy to install, and the mount at the seat aligns perfectly which is very important because the seat needs to be removed every time the bike is serviced. I had another aftermarket rack that had a serious problem with the seat mount that made it a nightmare to remove and install the seat -- this rack will never have that problem.Another thing I like is the dedicated mount points which are designed to hold the stock tool bag. I will be using those mounts to bolt on a small waterproof case where I will carry my camera and satellite phone. Behind the case there will be enough room to strap on whatever -- I use ROK straps which are the best ()Please note that this rack puts leverage onto the rear end of the sub-frame, so it should not be overloaded. I will never put more than about 10 lbs (4.5 kg) on it when adventure touring with fully loaded panniers. On the manufacturer's website it says the load limit is 20 lbs (9 kg).
Recommended Products
$159.76
$ 72 .99 $72.99