Your cart is empty.
Your cart is empty. Compatibility:
Work fit for chevrolet GMC Avalanche Express Silverado Suburban Yukon Sierra Tahoe 1500 2500/ LS LT Truck LSX 4.8L 5.3L 6.0L V8.
Only applicable to GM 3rd and 4th generation LS series engines, wet oil pan.
It is not suitable for welding flange installation of any LS suction pipe (gm#12608593, Holley 302-1 and similar).
It also does not apply to pick-up tubes (Holley 302-2 tubes and similar tubes) with two screw holes on the mounting flange.
Package includes：
1*Oil pump support
1*Bolt
The oil pump belt evenly distributes the clamping force around the pickup pipe flange as an extension of the flange, providing additional support to ensure that the pipe will not loosen
Madison
Reviewed in the United States on May 26, 2024
Good
mmarkakis
Reviewed in the United States on May 18, 2024
Good fit, came with the proper bolt.bolted right up fits good
Byron Owens
Reviewed in the United States on March 31, 2024
Works perfect! Saved me so much time and is very well made. Highly recommend to anyone and would definitely order again if I need another one
TRM
Reviewed in the United States on October 15, 2024
Had to modify oil pickup tube and drill bolt hole larger just to get it to fit. I'll avoid this company in the future
Jason Zeigler
Reviewed in the United States on April 7, 2024
I was working on an '05 Chevy Tahoe with low oil pressure. I decided to replace the o-ring and oil pump without dropping the pan. The radiator had a small leak so it made sense to go through the front anyways instead of messing with the front differential. The 10mm bolt holding the pump and pick-up tube is a pain and if anyone is doing the same repair, go slow and have a magnet or something to wrap around that bolt before removing it or it will drop into the pan. A long story short, trying to get that bolt back into the lower hole of the tube is next to impossible and will make you nervous trying not to drop that bolt. I picked this girdle up to bolt the pump into the upper hole. It still took quite a bit of playing around to get it right but I finally did. The girdle comes with a bolt but you would be better of using the original that came the lower hole. Once I got the bolt and pump back in place reassembly went smoothly. The Tahoe now runs idle at 40 psi. I was under 20 before. So far so good. It is made in China so I felt bad putting that in my GM.
Pepperseed
Reviewed in the United States on April 21, 2024
Machine hole wrong place did not line up
Thomas Dodson
Reviewed in the United States on December 30, 2023
I was replaceing o ring and decided it would be nice to have this on there but it didn't fit my truck with a L59 but hey it looked nice
Marcus Jarmon
Reviewed in the United States on October 4, 2023
Help to add a more secure lockdown for the oil pickup tube.
Recommended Products
