Your cart is empty.
Your cart is empty. This circuit board replaces Power Gear circuit board model numbers 14-1130, 14-1098 and 14-1086. The same fuse and breaker that is on the old board may be used on the new 140-1130. The 140-1130 controller will need the center wire on the wall switch to be a 12VDC (positive trigger) which on some models of controllers such as the 14-1098 are ground trigger.
Replacement:14-1130,140-1130,14-1086,14-1096,14-1098,246063,368859.
If you have an older Power Gear 14-1098 board on your RV,you need to have new holes to screw it in and make some changes to your wiring.
Ray
Reviewed in the United States on March 28, 2025
Quick shipping and it fixed my problem
MWG
Reviewed in the United States on January 9, 2024
Installed and worked perfectly. Not quite the build quality of the original power gear circuit board, non the less quite acceptable.
Customer
Reviewed in the United States on April 18, 2024
Love them
Customer
Reviewed in the United States on April 15, 2024
works well
JERRY & LUCIA
Reviewed in the United States on January 12, 2023
I used this module to replace an obsolete Power Gear 14-1098 module. The original 6 pin connector is an exact match for this upgrade. There is one modification needed which involves rewiring the in / out switch. The original switch sends ground signal for in / out operation. This module requires a 12 volt signal for in / out operation so the switch common needed to be rewired to power. I added an inline 5 amp fuse to the switch circuit for protection. The new module comes with the board mounted fuse but no circuit breaker and it needs both to operate. I was able to use the circuit breaker from the original module. For some reason the new module utilizes a fuse and a circuit breaker wired in series. Overall I was very satisfied with this purchase.
Recommended Products
$299.99
$ 99 .00 $99.00
$58.33
$ 26 .99 $26.99