Your cart is empty.
Your cart is empty.The TA018 current clamp is ideal for use with PicoScope automotive oscilloscopes for measuring currents between 10 mA and 60 A. This enables the PicoScope to display current waveforms for fuel injectors and fuel pumps. The current clamp has two calibration settings, set by a slider switch on the handle of the probe. 1 mV/10 mA (100 mV = 1 A — use this for testing currents up to 20 A. 1 mV/100 mA (10 mV = 1 A) — use this for testing current up to 60 A. In use there is no need to break into the circuit or disturb the isolation as the opening jaws simply clamp around the current carrying conductor. No electrical contact is required. These current clamps have been designed for use with PicoScope oscilloscopes and feature additional screening to reduce noise pickup. The Pico TA018 current clamp can either be purchased as an accessory within one of our popular diagnostic kits or individually under the packing code PP264.
Geri
Reviewed in the Netherlands on August 30, 2024
Zeer goed en uiterst nauwkeurig. Hoort in de toolbox van iedere automecanicien.
Jon
Reviewed in the United Kingdom on June 8, 2024
delivered as promised from the company well packaged. The picoscope is good quality and easy to use to check for current readings in cables and car wiring without breaking into the circuits. Ideal for fault finding in vehicles as powered from the battery 12/24 volt source.
Celtic tiger
Reviewed in Germany on March 15, 2024
It delivers a good clear signal ,that's what you get when you spend abit more for Pico
Sneaky Castro
Reviewed in the United Kingdom on September 29, 2023
Don't cheap out for the sake of saving a few quid, buy a pico. better sample rate and less zero drift than cheaper products. I have NEVER had reason to doubt the quality reliability and accuracy of pico measuring instruments. Will be buying a bigger clamp soon and you can bet I'll be choosing pico. I've done the cheaper route in the past and here I am.
Wade Krafft
Reviewed in the United States on February 10, 2020
Perfect!
John C. Opfer
Reviewed in the United States on January 7, 2020
Nicely made. Comes with cheapo battery, otherwise great. Auto off circuit would be nice to save battery.When measuring low currents with popular Rigol scope, signal to noise ratio is same as with 0.1 ohm shunt. (See scope traces.) Ten turns thru the clamp multiplies signal output so lower sensitivity can be used which cleans up the signal. I have not evaluated the high frequency response of this scheme. It will add inductance to circuit under test but as seen in scope traces, not a problem in this test.
Jason
Reviewed in the United States on June 5, 2019
This Pico low current clamp is well worth the money. I own a few others like OTC and Snap On what I like about the Pico is the 20/60 amp settings on my Snap On it’s 20/40 which is good for Lower resolution however sometimes it’s nice to go up to 60MA. Also people complain about don’t forget to shut it off don’t seem to realize that 90% of the scopes on the market have the same set up. This is worth buying 100%.
Xencer
Reviewed in the United States on January 9, 2019
Works very well for measuring current, just make sure to switch it off when you're done.
Marius
Reviewed in France on April 27, 2019
2gammes 20A 60A (Alt / Cont ) précision correcte
Brian B.
Reviewed in the United States on April 2, 2019
Works great for me. Good quality. Wish it had a battery timer to shut off after such and such a time because I tend to forget to flip the switch to off. But works great and does what I need it to do for sure.
Recommended Products
